I have a JWIN DTV3212 LCD TV with a BP-200AD power supply. With the help of this forum I was able to replace a bad capacitor, and get the set working again. It worked flawlessly for over a year, until a nearby ligntening strike. After the strike, there was a puff of smoke, and the TV went black.
I opened the box again and on the power supply was a small burn spot where (what I think) a resistor used to be. The resistor was completely gone with only the stubs left. I don't see any other (obvious) problems, and would like to try repalcing this Resistor(?).
The problem (I guess obviously) is I have no idea what to replace it with, as there is nothing left of it. The board is marked R10 right next to where the resistor was. I had thought that at one time I had found a picture of this power supply on this forum, but my searches have had no sucuess.
Does anyone have a scematic of this board. Even a good picture would work, and I may be able to identify the missing part.
TIA
Mike
I opened the box again and on the power supply was a small burn spot where (what I think) a resistor used to be. The resistor was completely gone with only the stubs left. I don't see any other (obvious) problems, and would like to try repalcing this Resistor(?).
The problem (I guess obviously) is I have no idea what to replace it with, as there is nothing left of it. The board is marked R10 right next to where the resistor was. I had thought that at one time I had found a picture of this power supply on this forum, but my searches have had no sucuess.
Does anyone have a scematic of this board. Even a good picture would work, and I may be able to identify the missing part.
TIA
Mike
Comment