hello,

i want to buy a new programmer mainly for use for laptops bios chips and i'm between the Xgecu T76 and the famous RT809H.
i think that T76 is faster wich makes it the best choice for using Pogo pins,i asked the support if it supports Mec ships found on some Lenovo laptops i didn't get an answer yet.

i would like some ideas and which one do you recommend?...

This is a shot in the dark, but I was just using my RT809H programmer and it got stuck in a certain state so I power cycled it. Now, the device LED just flashes quickly and does not connect to the software. I've tried to update the BIOS of it and it fails. I went so far as to remove the ROM from the programmer itself but it's some weird chip (I believe ATMEL, but I can't find any datasheet on it) so I've been unable to read the BIN from it w/ my other programmer. Chip has ATMLHC4C56BM CN written on it (I think). I'll upload an image. I have the programmer's BIN ready to program it manually. Anyone...

Hello fellow caps

I want to remove the Supervisor password on a Lenovo L490 laptop.
SIO is ITE8227
I understand that I need a jtag tool like RT809H to be able to talk to the chip and read/erase/write.
My question is:
Is the RT809H compatible with reading ITE8227 chips? I cant seem to find info on that before ordering the RT809H.

Hello all,
help needed.
I want to made backup of boot and all partitions from emmc desoldered from old phone.
So i have wired emmc directly to RT809h - Dat0, GND,CMD, CLK, VCC, VCCQ - on programmer sw set Smart Identify to EMMC ISP and voltage to 3.3V.
In Settings (N) i have set area to user, boot1,boot2 and EXT and vccq set to 1.8V (tested 3.3V too).

Problem is, that i still get Read Timeout Error

OK - emmc can be dead...so i have tested emmc wires connection to micro SD adapter and then in card reader and emmc was detected.

So...

I am trying to program the EC IT8886HE of a Lenovo V310-15ISK with RT809H. (Motherboard DA0LV6MB6F0 REV: E)

According to the programmer's software, it must be connected to the SM BUS of the EC (pins 87 and 88 if I'm not mistaken) through the ISP port of the programmer. However, when I want to read or delete the EC it tells me "bot error"

Someone has programmed these ECs to help me or tell me what mistake I am making. I leave the photos of the connection diagram, the error that appears and the photo of how I connected the ISP cables

Thank you so...