Re: Graphics card Schematics and Boardviews
Not Powercolor but gigabyte rx 5700xt....
dl123
New Member
Last Activity: 01-05-2024, 08:36 PM
Joined: 06-24-2021
Location: North Highlands
-
Re: Gigabyte RTX 2070 error 43 but no artifacts, crashes on driver load
Have you tried installing older drivers?...Leave a comment:
-
Re: Gigabyte RTX 2070 error 43 but no artifacts, crashes on driver load
I accidently shorted one drMos so 2 need to be removed or replaced. I don't have an oscilloscope so couldn't check that. After removing the 2 drMos chips the gpu started working. After time it kept getting code 43 again so I thought the gpu is dead. I then decided to transfer it into a newly built system and it started working again. The system installed old drivers automatically and im guessing that made it work again. The driver version is 457.51....Leave a comment:
-
Re: Gigabyte RTX 2070 error 43 but no artifacts, crashes on driver load
I had a similar issue on my zotac 2080 super extreme amp where I would get code 43 and mats passed without any issues all of the voltages were fine yet i got code 43. Turned out two drmos on one of the powerstages were bad....Last edited by dl123; 09-01-2021, 03:17 AM.Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Gigabyte aorus rtx 2060 and msi 2060...Leave a comment:
-
Re: Gigabyte RTX 2070 error 43 but no artifacts, crashes on driver load
I see you've been doing a lot of hunting to find the problem, hope you find the broken resistor. as for it not working after you remove the chips the heat probably completely killed the chip or resistor that was already dying. I need to look into those areas on my rtx 2080 and see if it has a similar issue.Leave a comment:
-
Re: Gigabyte RTX 2070 error 43 but no artifacts, crashes on driver load
Did you have any progress with the repair of this issue?Leave a comment:
-
Re: Gigabyte RTX 2070 error 43 but no artifacts, crashes on driver load
I have the same issue on my zotac amp 2080 super. I can boot into windows with code 43, mats run just fine. I was able to boot it once and it was working fine until i restarted my pc.Leave a comment:
No activity results to display
Leave a comment: