Spectronic PLTV-3250 32"

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Kevin O'Henly
    Ontario Member
    • May 2009
    • 48
    • Canada
    #1

    Spectronic PLTV-3250 32"

    Finally!
    I have a flat screen TV to save from the crusher.
    The fault is probably in the supply as the set is DOA.

    pictures to follow.
    Be yourself,
    everyone else is taken.
    Tags: None
    • Kevin O'Henly
      Ontario Member
      • May 2009
      • 48
      • Canada
      #2
      Re: Spectroniq PLTV-3250 32"

      Made by Proton Digital Corp.
      SpectronIQ Model: PLTV-3250
      Power supply model: FSP194-3F01

      Replacement PS may be available from ramplus.com
      and the phone # is 866-554-9925

      None of the required voltages are available: 5vdc, 16vdc, 24vdc

      Replaced two caps with low ESR and still no pulse.

      pictures to follow.
      Be yourself,
      everyone else is taken.

        Comment

        • Kevin O'Henly
          Ontario Member
          • May 2009
          • 48
          • Canada
          #3
          Re: Spectronic PLTV-3250 32"

          The Badcaps form thread covers this situation in some detail; with pictures.
          Refer to: https://www.badcaps.net/forum/showthread.php?t=6550

          Thank you for the followup at the end of the thread.
          I'll get a PS part on ebay and followup on the defective supply as well.

          regards,
          Kevin
          Be yourself,
          everyone else is taken.

            Comment

            • Kevin O'Henly
              Ontario Member
              • May 2009
              • 48
              • Canada
              #4
              Re: Spectronic PLTV-3250 32"

              The PS fault was the 15V zener diode near Q7.
              Replaced it and all is good again.
              Be yourself,
              everyone else is taken.

                Comment

                • PlainBill
                  Badcaps Legend
                  • Feb 2009
                  • 7034
                  • USA
                  #5
                  Re: Spectronic PLTV-3250 32"

                  Glad we could help.

                  Oh, wait, we didn't!!! Congratulations, you did it all yourself!!!!

                  PlainBill
                  For a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.

                  Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.

                    Comment

                    • Kevin O'Henly
                      Ontario Member
                      • May 2009
                      • 48
                      • Canada
                      #6
                      Re: Spectronic PLTV-3250 32"

                      THX, PlainBill.
                      I wish I could take some credit but the applause goes to:
                      glen65 (for posting: with pictures), eguevarae, Toasty (for making it real) & the others that participated in thread: https://www.badcaps.net/forum/showthread.php?t=6550

                      I just followed through on the great advice and good things happened.



                      rgs,
                      Kevin
                      Be yourself,
                      everyone else is taken.

                        Comment

                        Previous template Next

                        Related Topics

                        Collapse
                        • bohaboha
                          Samsung UE70TU6905 BACKLIGHTS AND SOUND ON NO PICTURES BUT SCREEN NOT DARK
                          by bohaboha
                          Hi it looks like everything works don't know where to test except the 390v in the 2 capacitor in the hot side of the power supply and the weird 180v in the diodes in the cold side that should be discharged it is writin on the circuit no more you can read what is written on the circuit quite srrange color mixiing yellow and white
                          anyhow i couldn't t read anything else
                          the backlight is on strong and the screen does not get dark or very dark but no pictures
                          the mainborad feels a bit hott on the black part i test it to 52 degree's against 34 to 40 on the rest of it
                          ...
                          01-02-2025, 08:04 PM
                        • valvashon
                          LG 55UH6150- trouble powering up, then half lit screen (pictures!)
                          by valvashon
                          The 55" LG has been in the basement for a few months without being used. Turned it on yesterday, set came on as it should and showed a complete screen for about 5 seconds (was on a broadcast channel but no antenna was connected), then the screen went mostly dark with about 1/3 of the screen on the right lighting up with brighter lines in that lit part (sorry, no pictures of that). Power LED was cycling too, preventing the TV from fully powering up.
                          Pulled the back off, all boards looked OK. Pulled the LED connector, turned the set on to see if it would power up but I don't belive it...
                          11-24-2024, 12:08 PM
                        • 2elw
                          SVOD4 PCB pictures + parts
                          by 2elw
                          Hey, I find it very absurd that the SVOD4 costs so much and has zero documentation. I had no other choice than to buy it to unlock ECs, if there was any documentation or firmware avalible I could've made it or something simmilar. Anyways here are some of the most important parts:

                          STM32H723VGT6 MCU - It's a microcontroller by STMicroelectronics and its the whole brain of the SVOD4. It has flash memory for the firmware which can be updated by the SVOD4 program. Its also powered by the AMS117 which converts 5v into 3.3V. 7€ on AliExpress.

                          GW1N-UV9UG169C6/I5 FPGA - Its a...
                          07-04-2025, 12:23 PM
                        • VitalComputing
                          Taking Pictures Of Large Circuit Boards
                          by VitalComputing
                          Hi friends,

                          I am trying to take good quality pictures of rather large desktop motherboards for a project I'm working on. I had a brilliant idea of scanning them with a flatbed scanner I have but it only focuses on the bits of the board that are flush to the scanning glass. And the through hole components tend to lift the main board from the scanning glass. Everything else just looks out of focus. So it seems that that option wont run.

                          I have been capturing the images with my iPhone 11 and it's okay but wont capture the whole board. I have to grab it in sections and...
                          11-22-2022, 04:15 PM
                        • E--Man
                          Samsung LED UHD TV - Bad Main Board or Bad T-Con Board? Pictures inside
                          by E--Man
                          Hi All,

                          Thanks for reading. Based on the interesting fact that the vertical lines issue don't seem to effect the menus whatsoever but rather everything around the menu regardless of video is shown, I'm trying to set mine whether the issue is the main board or the t-con board.

                          Again what's baffling is that the menu is not effected whatsoever. However, any other video displayed regardless of inputs or when no inputs exist exhibits the vertical lines and seem to effect black areas only.

                          The lines are green in color when the tv is in "Game Mode" and...
                          5 Photos
                          05-12-2024, 10:52 AM
                        • Loading...
                        • No more items.
                        Working...