is the the voltage reg or something else. sometimes it turns on if I leave it unpluggled for a link time,
42lz196 blinks red 3 times and sometimes turns on?
Collapse
X
-
Re: 42lz196 blinks red 3 times and sometimes turns on?
What brand of TV is this? This sounds like bad e-caps problem. -
Re: 42lz196 blinks red 3 times and sometimes turns on?
Yes, definitely a problem in the PSU, Also look for cold solder joint and reflow them, especially transformer legs, etc.Comment
Related Topics
Collapse
-
Just replaced all the LED strips and successfully turned on the set and even watched some HDR content, but then noticed a small piece of dirt dead center in the screen. Tried flicking the screen to get it to drop to the bottom as well as static-charging a cloth and rubbing it to make it go down the screen, but no luck.
So I proceeded to disassemble the whole set again. You can guess what comes next.
The set lights up fine, but blinks 3 red blinks and no menu or anything else. The screen looks fine, but there could be panel damage or a short. Also the lights stay on.... -
by brithepi2kMy Samsung UE75TU7020k lights up fine when one of the ribbon cables are disconnected from the main board, lights stay on but not getting half a picture, I do the same with the other ribbon and put the other one in and lights stay on but not getting half a picture. The standby light flashes 2 times then reboots then it then tries to come back on again and just keeps looping until I take either one of the ribbon tables out (doesn’t matter which one I take out it stays lit when either one is out). I’ve tested the backlights but all working with none shorting out, I’ve replaced the main board...2 Photos
-
by SamungggI've happened upon this TV, it came with no power cord or remote and it seems to be experiencing a common issue where the red indicator light blinks 2 times then the screen flickers as if it's trying to turn on. No picture, no sound. I suspect the functions of the TV are in good order and that the underlying issue is with the power button which is missing. It's just a white tab where the button should be which means I can't cycle it.
I wanted to know if there is anything I can do or if I should just get a replacement module with the hopes it will fix the system. Alternatively if... -
by mecha1166I have a XR-77A80K here. When plug in & press power, white lindicator light flashes on & off. about 30 seconds later, indicator light flashes 8x red. Checked Sony, Power reset = unplug & plug in. Factory reset involves turning it on, then pressing remote buttons when a picture shows. Well, neither of these "resets" are for a dead set like this. Anyone know what 8 blinks indicates, from the schematic? Thanks!
-
by magnehHi there
I have this set with no power, blinks power led twice.
This seems to point out to D board issue
My first question is which one is the D board?
The main board?
Or one of the power boards?
Are they labeled with this? (did not checked the boards yet)
Thanks for any inputs... - Loading...
- No more items.
Comment