Panasonic TNPA 5105 SC boards.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Techstar
    Tv Restoration
    • Dec 2012
    • 122
    • United Kingdom.

    #1

    Panasonic TNPA 5105 SC boards.

    Could any one please advise me if the TNPA 5105 Sc boards from a 46 inch or 42 inch Panasonic Plasma will work in the 50 inch Panasonic plasma.

Related Topics

Collapse

  • Erik Masters
    Panasonic plasma A boards/Kuro media box repair.
    by Erik Masters
    Hi all.

    I have 2 Panasonic plasma A boards for ST50 50"/65" and Kuro KRP 500A media box which needs repair.
    I'm not good enough at component repair so I need some help.
    A boards and especially Kuro media box is still very valuable and I can't throw it away like some average Joe,lol

    I'm from Europe/Slovakia and I'm searching for someone who is willing to repair these things or some tips at least.

    Both A boards have HDMI issue either no signal or flickering.
    And media box possibly with voltage regulator issue which is common...
    11-17-2022, 04:47 AM
  • jm1234
    Panasonic plasma TX-P42ST50 - 6 blinks
    by jm1234
    Hi,
    anyone able to provide the service manual for old plasma Panasonic TX-P42ST50E?
    It turns off almost immediately (0~5 seconds after pressing the on/off button) and starts flashing the red diode 6 times.
    I disconnected the left-hand side board (SC?, both the ribbon cable and the power cable to it) and also another ribbon going to bottom left board. Then the led signal is 8 flashes. According to service guide to another Panasonic plasma it would mean the left-hand side board is faulty. But I'm not sure it 100% applies to my model.
    I checked that board for any obvious faults...
    05-22-2024, 06:59 AM
  • ugamazing
    Three 820-01700 32GB Logic Boards Same Issue: Won't Wake From Hibernate
    by ugamazing
    I have three identical-spec 820-01700 boards (2.6/32/512), and ALL THREE boards came to us with the same fault, from different sources: The boards don't wake from hibernation with the keyboard or lid, they ONLY wake when you press the power button. I understand this is a very minor issue, but the boards must be fixed!

    We will of course begin with the obvious (checking lid signals), but I couldn't help but notice these three boards were all 32GB variants. Has anyone noticed an issue relating to these 32GB boards in particular? I of course don't think it's a RAM issue, but it's bizarre...
    12-17-2024, 07:05 PM
  • cloo
    Panasonic ZT60 plasma tv with strange behavior and 8 blink code
    by cloo
    I recently got my hands on a 60" Panasonic P60ZT60 plasma tv (european model) that has some strange issues along with an 8 blink code.
    It know this tv is getting old but it was once considered one of the best plasmas ever made, and i think it is still holds on to that even by todays standards.


    So, long story short. When i first got the tv it had a very bright washed out picture with very raised blacks in all picture modes and i couldn't find the cause in the picture setting menus.
    After doing a factory reset this problem was gone and the picture was back to...
    01-06-2025, 06:02 AM
  • Alicat
    Panasonic Plasma TH-50PZ85U No screen No blinks on red power light
    by Alicat
    Hello,

    Stopped by this site trying to fix my parents Panasonic Plasma TV.

    Model number is TH-50PZ85U

    Power comes on and the red power light stays on solid.

    Did a few checks like hold the power button on for 60 seconds, hold the - Volume while holding the menu button, no luck, still@ blank grey screen as the screen lights up very vague.

    I also hear a few clicks.

    I also think my parents said there was a thunderstorm and the TV failed after that.

    Section 6 in the service manual talks about power and no screen,...
    10-30-2024, 10:09 AM
  • Loading...
  • No more items.
Working...