Just picked up a 55 inch LG 4k OLED for $50!

[fob]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Hi Guys,

I'm a bit lucky, I purchased a 55EG9200 set that was non working. Panel seemed ok without cracks so I bought it as a project and for 100$CAD even if it was not repairable it was not a huge loss.

TV was refusing to power on. Main board did not send the commands to the power supply to turn on.

I do not have the remote so I downloaded anymote app and with the LG remote on the app the POWER ON button (POWER ONLY command i think) the set came on and seems to be working fine. It's stuck on HDMI1 and if I plug in my PC it displays fine.

However the TV is unresponsive to the other remote functions, unable to turn off the set or change inputs. Even the front button does nothing.

Any clue what is the issue?

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Good to hear!

[Robs1984]

Re: Just picked up a 55 inch LG 4k OLED for $50!

just to contribute to the thread that helped a lot in my situation, I could like to clarify that power-only works only if you connect one pin of the leds to ground and the other to signal.That is because it is a mono file, not stereo. At least that is how it worked for me.
Thanks!

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Well this is a pleasant surprise. The streaks and spots have gone away. There's some minor vertical banding but it's much less distracting.

Thank you compensation cycle! You seem to do the trick every time!

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Well this is a pleasant surprise. The streaks and spots have gone away. There's some minor vertical banding but it's much less distracting.

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Nice--thanks for clarifying.

Unrelated--it occurs to me that my TV was out of commission for a week and a half and no one in my family cared. Thanks, mobile devices.

Lol same here. 3 kids and a wife. House full of tablets. As long as Comcast stays up everyone seems happy.

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

UA tcon is UA specific. It appears that it does not support the Hi data that HDR puts out.


This is the primary reason why LG said UB is not compatible with you a due to the fact that manufacturers consider tcon as a part of a panel. When you swap tcon the panel is manufactured with the same principle as in only accepts what the tcon is throwing at it.

Nice--thanks for clarifying.

Unrelated--it occurs to me that my TV was out of commission for a week and a half and no one in my family cared. Thanks, mobile devices.

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

UA tcon is UA specific. It appears that it does not support the Hi data that HDR puts out.


This is the primary reason why LG said UB is not compatible with you a due to the fact that manufacturers consider tcon as a part of a panel. When you swap tcon the panel is manufactured with the same principle as in only accepts what the tcon is throwing at it.

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

The HDR looks great; and it's nice to have a lot more content with my Shield and XBone than just the couple apps offered through LG. Plus I can have HDR and atmos together. Before I'd have to pick between the two since the TV didn't support atmos.

OK magic remote paired--thanks. I'd tried that already, but now realize I misunderstood what the home button was in the instructions. I'd been pressing the wheel.

I still would have assumed the board swap wasn't possible if LG Europe wasn't performing the upgrade gratis.

I'm curious if swapping the UA-only T-CON is even necessary. Not curious enough to try.

Happy to sell you the other UB mainboard. PM incoming.

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

P.S. I love how techs at LG said UA to UB swap is not possible sense the panels are different.

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

That's awesome how does the picture look with HDR content? I'm currently looking to replacing the HDMI codec processor on my UB mainboard so i can slap my TV back together.

On your LG magic remote hold down the home button and the back arrow at the same time for about 10 seconds until the power light lights up on the remote. Then point at your TV go into the settings menu and I believe from there you can adapt it to work with the TV the only thing is the remote has to be reset with what I told you Sense it's still adopted to your old main board.

Also do you want to sell me you're old UB mainboard because I could probably use the H DMI codec processor up that board to get mine working? Pm me if you want.

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

UA-to-UB Upgrade complete! The mainboard was the issue. That $20 untested mainboard was a good gamble--it works like a charm. Certainly better than the $120 "fully tested and functional" mainboard.

While I was in there, I swapped out the T-con for another, just to see if I got any improvements. It has less clouding, but similar dark streaks on the side, and that image retention square is still there and I still can't figure what it'd be from. It's a bit distracting during lighter gray scenes, but passable.

That service remote is definitely necessary, because the TV does not work perfect immediately after the swap--but all is fine after a P-only cycle.

Only other issue at this point is my LG magic remote doesn't pair with it, but my Logitech works fine with it so I don't really care.

Just very happy to finally have HDR over HDMI!

Thanks a ton for your help!

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

thanks, seems to help some. it was definitely too bright before

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Try setting to ISF expert 2 mode, turn brightness to 44.

My set actually has that same banding clouding issue when the brightness is turned up. Who knows it might be just something with these UA/UB tcons. Although I can't personally vouch for how the TV looked before the tcon replacement since I didn't have a chance to see.

My TV with these settings looks absolutely remarkable

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

I've attached an image of the screen as it stands right now. Aside from those circles in the background, that gray is supposed to be fairly uniform. The white splotching is much worse than earlier and cover significantly more area. Also notice the rectangle in the bottom? No clue what that would have come from.

On a good note--the regular old menu "return to factory settings" did the trick on getting my software quirks out. Haven't done a long test to see if the video shuts off, but at the very least I can turn the TV on and navigate like a normal person again.

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Can you provide a picture of what you are seeing on the screen?

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Yes Id worry about in-stop as well.. I have heard that there are settings pre defined that will not be able to be replaced without the info from LG. Im leaning on tcon error if it keeps repeating this.

[kevlar51]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Wierd. Try a factory reset? Also can't confirm if the UB tcon you got has some issue as well. It has the power down I2C communication with mainboard if somethings not right. I think that the service menu may have error flags I'm not sure.

I'm leery of a factory reset. I know the regular main menu allows you to "reset settings," and I haven't tried that yet. But I think digging in to reset to original pre-leaving-the-factory settings with in_stop can brick it.

Could be you need a firmware update. Some OLED's had problems with the panel because of firmware.

Firmware's up to date, and unfortunately they don't give you the option to re-install current FW.

[Moreno83]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Could be you need a firmware update. Some OLED's had problems with the panel because of firmware.

[freakaftr8]

Re: Just picked up a 55 inch LG 4k OLED for $50!

Wierd. Try a factory reset? Also can't confirm if the UB tcon you got has some issue as well. It has the power down I2C communication with mainboard if somethings not right. I think that the service menu may have error flags I'm not sure.