47pfl3603d/27

[tvtimmy]

I got this tv in Jan. and it had the arcing transformer solder joint. Fixed it( 5th set with this ). Tv turns on and plays great. I gave it to my aunt and she loved it. She called me last week stating that when you turn off the tv it starts clicking 6 seconds later.
I picked it back up and it tries to power itself on after 6 sec. It cycles every 5 seconds. To turn it back on you have to time it just when it starts to click or unplug and plug back in.
I did a firmware update but no change. All the caps look good and I didnt want to remove them if I dont have to.
Anybody have a clue as to what is going on?

[kgavionics]

Re: 47pfl3603d/27

without troubleshooting this would be too difficult to know what's going on.
I need picture of the power supply board, i need also the voltages on the connector of the main power supply.

[R_J]

Re: 47pfl3603d/27

Not all caps leak or bulge when they go bad, especialy the small ones like 22uf 50v etc. Usually if it does start after multiple trys its a cap. Check and see what your standby voltage is and if its droping when it trys to start.

[tvtimmy]

Re: 47pfl3603d/27

Ok. I will open it up and report back.