Goodmans LD3265D1

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • dick_barton
    Badcaps Legend
    • Aug 2015
    • 6642
    • Wales
    #1

    Goodmans LD3265D1

    Picked up this set earlier with the complaint that when switching the set out of standby it would return to standby within a few seconds.

    Opened up the set up only to find a large number of blown capacitors in the power supply which was a Vestel 17PW20 V1. Replaced 13 capacitors in total and now the set is up and running.
    Attached Files
    Willing to help but I'm no expert.
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • cruiser_
      Vestel 17IPS71 + 17MB82S - no standby
      by cruiser_
      hello there,
      I am trying to fix a Walker 40 TV - it has Vestel 17IPS71 3R3 as PSU and 17MB82S for logic.

      How I got here...
      The TV had shorted USB connector, which I fixed. TV turned on. Ran for a few hours on HDMI input. Started to see some dark dots/patterns on the screen as seen on the photo.
      I restored to factory setting. The TV has rebooted only to a blinking standby LED. It sat there for a number of minutes after which I disconnected it.
      Now, after plugging it back in - there is not even a standby LED.

      My 17IPS71 provides 12V, no standby...
      11-25-2021, 12:48 PM
    • Adenitz
      Troubleshooting Vestel TV, has standby, but cannot turn ON
      by Adenitz
      Hello,
      I need advice in troubleshooting Telefunken TV (it is actually Vestel). There is red Standby light but TV cannot be turned on either by remote control (which is good and tested on another TV) or by actual on/off switch at the back of the TV.
      Power board is Vestel 17IPS71 and I'm not sure about the mainboard, it seems like 17MB82S
      Both boards are shown in the attached photos.

      What is normally first that is checked in this case. I have removed power board, make sure it has no dangerous voltage on the big caps and check many components (transistors and diodes)...
      12-27-2023, 03:43 AM
    • Aivar1988
      JVC LT65VU83K Vestel 17MB130P no standby light
      by Aivar1988
      Hello!
      Bought a used TV last weekend and everything was fine when I tested it. Back home I tried to connect it with my PC via HDMI. I noticed that the picture didn't quite fit in the TV's picture and so I tried to change the output resolution on my PC and then changed the picture formats on the TV. I still didn't get the picture right and stopped to google the problem and then it happened - the TV died on me after I got to use it for 30min.

      JVC LT65VU83K Serial nr. 7975101 800044
      Panel: VESTEL VES650QNTS-2D-U11 Manufactured 18/04 23443739
      Power board: VESTEL...
      08-31-2021, 05:47 PM
    • tvguy12012012120
      Zombie Samsung UN55NU6900F dead / no standby voltage - randomly came to life after hours of troubleshooting then died
      by tvguy12012012120
      This is my first attempt at troubleshooting a board like this, I know I could just buy a new board but I'm curious to figure out how this works. I've been testing different components in the evenings this week and I think the problem is with the IC failing to start up for some reason. When the board is plugged in there is no standby voltage.

      Then today it randomly sprung to life like a zombie but shortly died thereafter. I have no idea why it would have done that and its the first time I've seen it running. I discharged capacitors on the board last night, then it was sitting today....
      02-07-2025, 05:13 PM
    • ray14324
      Telefunken LED TV with no standby linght equipped with Vestel 17IPS20 PSU
      by ray14324
      Hi everyone,

      Searching the forum revealed loads of issues with this type of power supply board however I could not find a solution to my issue from them. Excuse the "another Vestel" thread

      The full story was: my Telefunken TV did not have a standby red light after of series of power outages in a couple of minutes. Sadly in my rural city the only technician that fixes TV's is away these days as I cannot reach him by phone. I want to try to have a go at it (with the internet's help).

      Reading into this symptom the general consensus was that...
      08-31-2021, 07:55 AM
    • Loading...
    • No more items.
    Working...