Got a lg 42pj350 it has the clicking from the ps. I ordered the repair kit but it still clicking. Sounds like 3 clicks from the relays! I have isolated it to the ps board. Disconnected all other board. What should I look for now.
-
-
Re: LG 42pj350 clicking still after repair kit
There's a Youtube repair on this supply
https://www.youtube.com/watch?v=rv6qvNcDtHUWilling to help but I'm no expert. -
Re: LG 42pj350 clicking still after repair kit
did u change the 2 resistors?Comment
-
Hi all!!
Ok just got a Onkyo SKW-593 sub woofer that has no power person told me that it smoked and that his GF let the volume full when she powered off the amp and when he came to turn it on the sub played but then suddenly smoke was coming out, didn't say from where. So opened it up and saw a resistor made of metal (pic) but can't see any writing on metal par so what ever was written on it was burnt. So I'm kinda stuck here with this. I did ask for a repair or schematics in the other group section and waiting for this but I hope someone here might lend me a hand to try and identify... -
PSU - BN44-00878A
Symptoms:
The TV turned itself off, and I haven't been able to turn it back on. The standby voltage was unstable and lower than it should be.
A weak clicking sound was coming from the transformer.
Video with clicking sound:https://www.youtube.com/watch?v=lAduhjNtqCA
Progress:
After the transformer, I measured four Schottky diodes. DM862C and DM864C diodes readings were 003 in both directions. After detaching them from the circuit and measuring them, DM864C was the shorted one. These Schottky diodes are SB550.I... -
Hello!
TL;DR: Replaced blown Q801, Q802 and fuse, but it didn't fix the problem.
I'm trying to repair this TV, since it developed clicking symptom. I disconnected Y-SUS and Z-SUS boards, but PSU was still clicking, so then I was sure problem lies in PSU. When you plug it in, you can hear 2 clicks from relay and then one click when it shuts down. I found two shorted mosfets Q801, Q802 and blown fuse F801. I replaced those elements, but it's still doing the same.
After some research, I found out resistors R108-113 need to be checked and sure one was showing... -
Hello, I bought this Mac from a friend, he said that it simply stop working. The MacBook looks very clean but does not power on, stuck on 5v 0.42A, and sometimes display 5V and 0A (then 0.071A and again 0A).
I opened it looking for some problem, it was not touched before for sure and the board is very clena, no spot of corrosion at all from what I can see. Voltage on multimeter of the board off the case it's the same, 5V 0.42A. But then I noticed this "clicking sound" come from the board ( I attached here the audio file).
Looking on google I found this:... -
Bolstered by the guidance provided in this thread - https://www.badcaps.net/forum/showth...61#post1003961, I ordered a replacement Power Supply Board and read through the 'training' manual linked in the thread in preparation to install the new board (and solve the faulty startup process). I have two questions:
1) My 42PJ350 was produced in Mexico and the ID plate *does not* have the Vs/Va voltages stated below the mains voltage. The line below the 'Power' is 'Manufactured' with no space/line between to provide the configuration voltages. Is there a known fixed voltage...
Comment