Lg 60pv250 ysus

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • krygods
    Badcaps Veteran
    • Dec 2014
    • 257
    • USA
    #1

    Lg 60pv250 ysus

    I'm troubleshooting the YSUS from a 60PV250 which had a open fuse FS104.

    I replaced the fuse and its open again so I started testing all the transistors and diodes on the heat sinks didn't find anything out of order there.

    Tested all the diodes on the bottom of the board and found D417 which shows a voltage drop of 103 in both directions.

    The marking on the diode is 83 and then 19 right below that. I can't seem to find any info in this diode. Anyone that can help with identifying this part I'd greatly appreciate it.
    Attached Files
    Last edited by krygods; 11-25-2015, 01:27 AM.
    Tags: None
    • Hamie
      Badcaps Legend
      • Apr 2014
      • 1383
      • UK
      #2
      Re: Lg 60pv250 ysus

      Have you removed it from the board and tested it?

        Comment

        Previous template Next

        Related Topics

        Collapse
        • Dvsr
          On M-Audio AV40 active studio speaker's two zener diodes get really hot.
          by Dvsr
          Hi. I need help from wiser guys. I am amateur in electronics and can't figure this out by myself.
          I bought faulty speakers, M-Audio AV40's. Other speaker has all the electronics in it and the other speaker is just passive one powered by the other speaker's amp. Original problem with the speakers was loud buzzing. I figured out that there is something wrong with the capacitors. I went ahead and replaced every electrolytic capacitor on the PCB. The caps are good quality and have the same values as the original ones.
          After replacing the caps I started testing out the speaker. It seemed...
          4 Photos
          09-10-2025, 10:20 AM
        • PlasMatt
          LG 60PV450 Possible Bad YSUS Need help confirming Diagnosis
          by PlasMatt
          I have an LG plasma that after reading through a bunch of posts and doing some testing I believe has a bad YSUS board. The problem is that that doesn't make sense to me for some of the symptoms. The problem started yesterday. While watching a movie the TV just shut down like I pressed power. I have it hooked to a PC and use RS232 to turn it off and on so I thought maybe something had glitched there. I turned it back on and finished the movie with no problems. The same thing happened today so I checked logs to see if something in the control glitched and sent an off command but it didn't, After...
          09-20-2025, 06:50 PM
        • caspian
          What Zener Diodes on a Linear Power Supply
          by caspian
          Dear members,

          I have a linear variable power supply with unknown brand name that I used for voltage injection.
          Then it failed. I discovered that its transistors (Q1 and Q2) are shorted.
          In addition, I discovered that its zener diodes are defective.
          I can replace the burned transistors.
          But I do not know the model of the zener diodes. the model number is not marked on the zener diodes.
          Therefore, I cannot replace the zener diodes.
          I do not want to test the zener diodes in a test circuit to discover their model or value.
          no schematics are available...
          05-26-2025, 12:38 PM
        • asr
          Finding replacement diode iPad Pro 3rd gen A1701
          by asr
          Hello, I am looking for help to replace a damaged diode. The tristar was replaced and a diode was damaged in the process. I have a picture of the diode but dont have an exact donor. I mostly have macbooks for donors and only a few ipad and iphone boards. Diode part number: DSF01S30SCAP
          Im not sure where to find the ipad board number. Anybody have an idea where else this diode is used on other boards? Thanks....
          07-09-2024, 06:24 PM
        • unimatrix93
          TV backlight zener diode
          by unimatrix93
          Hello everyone, I'm repairing an LG TV backlight and I noticed some strange behavior when I touching the backlight strip with a missing Zener diode.

          So I replaced the leds on the strips and they seemingly working fine, but soon as I touch the strip which has a missing Zener diode the whole backlight turns off for a few seconds and then turns back on.

          Is this caused by the missing diode? If so what kind of zener diode should I use to replace it?.
          ​​​​
          The led strips has 9 6V leds.


          ​​​
          1 Photo
          02-10-2025, 12:13 PM
        • Loading...
        • No more items.
        Working...