LG 60PS8000 Plasma - Blue Solarized Strange Picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • doganator
    Member
    • Aug 2014
    • 10
    • uk

    #1

    LG 60PS8000 Plasma - Blue Solarized Strange Picture

    Hi Everyone,

    Firstly, as this is my first post here. I'd just like to take the time to thank everyone here for their vast wealth of knowledge that can be found on this site. It has made for very interesting reading.

    The fault I am looking for help with is that I am getting a blue solarized effect across the whole screen. It seems to be concentrated on darker areas of the picture. (As shown in attached picture).

    I have tried a factory reset from the standard menu with no change.
    I have a code to enter an installation mode, ie. hold down menu - 1105 OK.
    But there is little to change in this menu. (Hotel Mode etc)
    I know this fault can occur when the AV board is set to output to a different size of panel, but I can't find a service menu that allows me to change this.

    I have been reading up on here a fair bit and from my research I believe I may have a faulty control / T-Con board? Could anyone help me to confirm this?

    I have re-seated all cables between all boards (apart from the ribbons between the Y-Sus & Buffer boards / Z-Sus & Buffer Boards.

    I have tested the Vs & Va Voltages.
    Recommended Settings Vs - 68 / Va - 194
    Actual Voltage Found Vs - 64 / Va - 201

    I have adjusted the voltages so that they are now correct. However, this has had no effect on the picture.

    There are 4 adjustment controls on the Y-Sus which for the moment I have left well alone.

    There are 2 LED's on the control board itself. One of which stays on permanently. The other does a long blink, followed by a short blink and then repeats in cycles of 2.
    I know that the LED's can sometimes read out error codes, however I'm not sure if this is just normal operation?

    The chap this TV has come from has informed me that the AV Board was faulty, but from what I have been reading, this seems unlikely. Could anyone help confirm this? I don't think he was a particularly technical person.

    There are plenty of Control / T-Con Boards available second hand for reasonable prices so i am happy to replace it. I just thought I would check with people here to see that it is the most likely culprit before shelling out the money.

    Any help, advice or guidance would be very greatly appreciated!

    Many Thanks,
    Regards,
    George.
    Attached Files
  • tom66
    EVs Rule
    • Apr 2011
    • 32560
    • UK

    #2
    Re: LG 60PS8000 Plasma - Blue Solarized Strange Picture

    This does look like a main board problem. We have seen similar issues on a similar model before, on 50PS80.

    I had a 50PS3000 (same panel and family, 50" and not THX, but basically identical) and the LED did the same thing.

    Try this: On the control board (the one with the blinking LED) there is a header marked AUTO_GEN. Use a piece of wire or alligator clip to jumper the 1st and 2nd pins. (Pin 1 marked by arrow.) Unplug the silver cable between the main A/V and control board. Then plug the TV on and take it out of standby, you should get cycling test patterns on the display.
    Last edited by tom66; 08-10-2014, 04:09 PM.
    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

    Comment

    • Clydeuk
      Senior Member
      • Jan 2012
      • 193

      #3
      Re: LG 60PS8000 Plasma - Blue Solarized Strange Picture

      It looks like an LVDS signal problem, I've seen this a lot on LCD displays most noticeable on lowlight areas of the picture. The problem could be any from a bad LVDS cable (you say you've reseated the cables), possibly try cleaning/testing continuity of the individual connections from this cable. Other than that it is likely one out of the 3 areas, either the cable itself (continuity check should reveal), the main board, or the control board.

      The post above should help confirm that the fault is not the panel or drive sections.

      Comment

      • doganator
        Member
        • Aug 2014
        • 10
        • uk

        #4
        Re: LG 60PS8000 Plasma - Blue Solarized Strange Picture

        Hi Guys,

        Many Thanks for such quick replies.

        Tom - I have done as you said and generated the test pattern. All of which comes through absolutely fine. No solarizing on the picture whatsoever.

        Does this confirm that it is indeed the AV Board?

        Clyde - I have re-seated all the cables on the control board and AV board. I cleaned the LVDS Cable at both ends, but have not run a continuity test on the cable. The cable looks to be perfectly fine, is it common for a cable like this to fail?

        I can (I think) get a new AV Board for around £28 so fairly inexpensive really.

        Would you recommend trying this first?

        Again, I greatly appreciate your help with this.

        Regards,
        George.

        Comment

        • tom66
          EVs Rule
          • Apr 2011
          • 32560
          • UK

          #5
          Re: LG 60PS8000 Plasma - Blue Solarized Strange Picture

          I have encountered LVDS cables failing, however I have found in all cases, if they are moved they start working (if only briefly.) So I would go for the A/V board at this point in time.
          Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
          For service manual, schematic, boardview (board view), datasheet, cad - use our search.

          Comment

          Related Topics

          Collapse

          • KYBOSH
            Hitachi 55HDS69 55" Plasma TV - No Picture But Sound
            by KYBOSH
            Picked up a bahemoth plasma TV not too long ago and just now getting around to looking at it.
            No picture but you hear the TV static (white noise) playing loud and clear.
            The back was already taken off (and no screws were provided) as the previous owner had already taken a look.
            But it seems they didn't get too far and just left it.

            When I first took a look I was amazed at how pristine the inside looked.
            Its as if the TV had been in a time capsule.
            Caps looked like they were just pulled off the self.
            Copper coils had no sign of corrosion on...
            02-01-2023, 11:10 PM
          • KYBOSH
            Trying to Save - LG 60PH6700 60-inch plasma HDTV - Powers ON but no picture
            by KYBOSH
            Saved this beast from the landfill this weekend.
            Manfactured July 2013 in Mexico.

            I love working on plasma TVs.
            Its been a while but I was lucky enough to find 2 this week.

            The TV powers on and stays on but no picture. Havent checked for sound yet.
            No bulging caps although the insides are pretty dusty and the boards are discolored from many years of high heat.
            Will start troubleshooting tonight.

            ...
            10-17-2024, 01:17 PM
          • Tr0ll
            T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
            by Tr0ll
            Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

            The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

            Original T-con:
            Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

            First replacement T-con:

            I thought it might be t-con and ordered new t-con from china(supposedly tested)...
            10-07-2023, 07:48 PM
          • Ted29946
            LG 50PG20-ua Plasma TV repair help
            by Ted29946
            I'm new to this so I hope I'm doing it right So....I picked up a LG 50PG20-ua Plasma TV (Someone's throwaway pickup) First power up no picture or sound

            Found power board to be bad and I repaired it. (Bad caps) Now all power volt readings are good. Still no picture or sound. I plugged in power cord, no click and the standby light on the on/off button comes on blue as soon as it is plugged in and does not turn off when button is push. I then pulled the main board off to look at it better and the initial inspection (front and back) I cannot see anything bad. Before I put the board back
            ...
            10-24-2024, 11:12 AM
          • JJAAMM
            SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
            by JJAAMM
            This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

            Problem
            TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
            07-06-2023, 06:01 AM
          • Loading...
          • No more items.
          Working...