Jmb jtc012600102b

[tom66]

Re: Jmb jtc012600102b

haha ok ive just started in this really and im enjoying it as a hobby so there should be more on the go soon, i dont like giving up though but then i got this sammy plasma which is becoming a bit of a headache...plasmas just cost too much for parts but ill give it another go hopefully one comes up with a smashed screen on ebay. cheers for your help mate.

Plasmas are the easiest for me to repair, but I have a scope, precision DMM and access to a lab at work full of equipment I can borrow for the night, without which repairing plasmas would be very difficult indeed. I've got three in my cramped dorm room right now, all Panasonic. Two work perfectly, one needs a little work but should be fixed soon.

[tom66]

Re: Jmb jtc012600102b

sounds good i want a decent nas drive to stream around the house and hopefully a mini pc for the back of the living room lcd with windows 8 installed

I'm building a FreeNAS (NFS) server which will hold the XBMC databases & 2x1TB HDDs in RAID, plus gigabit ethernet, allowing four simultaneous 1080p (or six 720p) high bitrate streams without running out of bandwidth. That should be more than enough. For the lounge there's a media PC, which runs Windows 7. The basement & bedroom TVs will have Raspberry Pis hooked up to them. Raspberry Pis are dirt cheap (£30 ish) and very capable little devices, can easily stream 1080p content.

[Mtek325is]

Re: Jmb jtc012600102b

Just an update on this thread ive put a new power board in and still the same problem...
Bit annoying so i think ill change the inverter board and give that a go i have noticed the ic chip on the board is really hot to touch i mean like an iron so maybe there's a problem on the inverter. Fingers crossed or its going in the skip.

[tom66]

Re: Jmb jtc012600102b

Just an update on this thread ive put a new power board in and still the same problem...
Bit annoying so i think ill change the inverter board and give that a go i have noticed the ic chip on the board is really hot to touch i mean like an iron so maybe there's a problem on the inverter. Fingers crossed or its going in the skip.

Well, if you're throwing it out, I can save you the trouble of throwing it out. I will be quite happy to pick it up within Basingstoke.

[Merger18]

Re: Jmb jtc012600102b

Hey, a fellow Basingstoke resident! Well, I live in Tadley (~10mi from Basingstoke), and go to university in Leeds, but I'm back in a few days time.

Anyway, I have a schematic for this board...
http://www.toms-service-manuals.com/...&Search=Submit

What mode is your meter set on? Volts AC or DC?

Hi could someone please help me i have the sane fault. Tried a new power supply and exact same so fault is elsewhere any ideas anyone would really appreciate help