H96 Pro Plus android TV box only shows blue light

[usyusy]

Re: H96 Pro Plus android TV box only shows blue light

you have open circuit / cut rail of ram /cpu

thanks for guidance but sir how can i confirm/test it, as i have no schematic for it.

[Diah]

Re: H96 Pro Plus android TV box only shows blue light

Thx
Coils resistance seems ok
DC supply was used which was of 3 ampere.
even tried to flash but stuck on 2%

you have open circuit / cut rail of ram /cpu

[usyusy]

Re: H96 Pro Plus android TV box only shows blue light

Thx
Coils resistance seems ok
DC supply was used which was of 3 ampere.
even tried to flash but stuck on 2%

[Diah]

Re: H96 Pro Plus android TV box only shows blue light

its firmware.... since the chipset Amlogic.... put it in download mode and flash it.. if it wont go to download mode,,,, on the Nand short pin 6-7 then plug in DC

[diif]

Re: H96 Pro Plus android TV box only shows blue light

Check the resistance to ground of the coils. They are the squareish devices with R2R and 1R0 etc marked on them.
Is there anything on the underside of the PCB ?

[nomoresonys]

Re: H96 Pro Plus android TV box only shows blue light

Looks like you can update to android 10, which would make it more compatible with the current environment than android 6 or 7: https://gofirmware.com/content/h96-p...-to-android-10

[nomoresonys]

Re: H96 Pro Plus android TV box only shows blue light

To be clear, I would take it out of the case, then put ventilation holes in the case so nothing gets a hole that isn't suppose to.

[nomoresonys]

Re: H96 Pro Plus only shows blue light

I see from your picture that you have it out of the case, do you see anything that looks like a reset button?

[nomoresonys]

Re: H96 Pro Plus only shows blue light

The 2 amp power supply it comes with is under powered, try a 5 volt 4 amp power supply, also they run hot, so any way to cool them will help, some put holes in the bottom of case and sit them on a small fan, laptop fan would work, need to be careful if putting holes, don't want to puncture anything inside. I would probably try to improve the cheaply done heatsink and or use a fan and maybe take it out of the case and put ventilation holes all over the case, like I did with the cover of my firesticks.

[usyusy]

H96 Pro Plus only shows blue light when connected to charger (tried a few even dc supply 5v), no powered-on and no display. However DC Supply showed 100mA or 110mA usage. any suggestion or clue from fellows will be appreciated.,.regards

H96 Pro Plus
CZ-S32-V3 (DDR4)
2016-12-15(A15)