Wine Enthusiast wine cooler, no power. Model # 272 03 29

[redwire]

Re: Wine Enthusiast wine cooler, no power. Model # 272 03 29

It's so you can take out the board and put it back in, without screwing up the connectors. Did you notice four are all the same 2-pin connector and can get mixed up!
I use a felt pen and put a stripe or dot (or two), or you can use masking tape etc to label the wires - CN1 (connector 1) etc. FAN, TEMP SENSOR, LEDs, PELTIER module etc.

[sam_sam_sam]

Re: Wine Enthusiast wine cooler, no power. Model # 272 03 29

I'd like to do it on a table, why would labeling wires help me?

The reason for doing this is IF you have a bunch of wires that are the same exact color or IF you have connectors have the same profile

How will you know which wire OR which connector went where

If you hook wires or connectors in the wrong place at a minimum nothing will happen or the hole board could go up in flames or blow fuse or circuit breaker

This is the reason for labeling wires or connectors and take pictures

I hope this helps you understand why I made this comment before

I do this most of the time when I work on board unless the board is marked with the wire number or jumper number and even then I will take pictures of the board any way

[rivera2j]

Re: Wine Enthusiast wine cooler, no power. Model # 272 03 29

Hi. I am new to this. Obviously i have the same problem as many of you have with this board ("c-110-cd"). I've seen a number of boards that looks like they can do the same as this one ("c-110-cd") Has anybody replaced the ("c-110-cd") with a FX-102?

Thanks!

[rivera2j]

Re: Wine Enthusiast wine cooler, no power. Model # 272 03 29

https://www.aliexpress.com/item/1005...68eeffd6e6fd-0

[sam_sam_sam]

Re: Wine Enthusiast wine cooler, no power. Model # 272 03 29

I would recommend that you replace all capacitors that are 100uf and lower unless you have a ESR capacitor tester and if you can compare to a new one is even better

If you decide to buy a new switching power supply for this device I would still recommend that you recap this this switching power supply if it has non brand name capacitor manufacturers