MSI GF63 12UDX-234XPT - MS-16R81 VER:2.0 - Schematic needed

[durango legrand]

pu24
IC CONVERTOR,MPS/MP1613GTL-Z,SOT583-8pin,3A SYNCHRONOUS STEP-DOWN CONVERTER WITH SS & PG,HALOGEN FREE

Many thanks

[noname2024]

Hello friends I'm working on this MSI MS-16R81 V2.0 motherboard and I noticed that there is the PU24 chip which shorts the +5VSUS line and prevents the board from booting. I removed it but I couldn't find its datasheet or the schematics of the card to replace the ship. Can anyone help me with the motherboard schematics or the ship datasheet? Thanks in advance

pu24
IC CONVERTOR,MPS/MP1613GTL-Z,SOT583-8pin,3A SYNCHRONOUS STEP-DOWN CONVERTER WITH SS & PG,HALOGEN FREE

[phamduy221]

Hello friends I'm working on this MSI MS-16R81 V2.0 motherboard and I noticed that there is the PU24 chip which shorts the +5VSUS line and prevents the board from booting. I removed it but I couldn't find its datasheet or the schematics of the card to replace the ship. Can anyone help me with the motherboard schematics or the ship datasheet? Thanks in advance

IC MP1613

CAN YOU READ ME KB9548GF 160KB ROM

[durango legrand]

Hello friends I'm working on this MSI MS-16R81 V2.0 motherboard and I noticed that there is the PU24 chip which shorts the +5VSUS line and prevents the board from booting. I removed it but I couldn't find its datasheet or the schematics of the card to replace the ship. Can anyone help me with the motherboard schematics or the ship datasheet? Thanks in advance

[camisao]

Hi,
I found the laptop problem.
The 5V output was shunted to ground.
After some time with the multimeter I found that the problem was the USB Power switch on the port I connected that was damaged (G517).
After removing it the 5V output was working and the laptop was able to start.
Oredered a replacement.
Found the datasheet for the Power Switch in the Forum.
Thank you.

[camisao]

Hello,
I need your help finding the MSI GF63 12UDX (Board MS-16R81 VER_2.0) schematic.
I accidently inserted MSI USB a programmer that was connected to a board that has Neutral tied to GND, instead of connecting it to the USB-ISO that was on another port (Friday afternoon mistakes....).
Now it doesn't start. 😏
I've looked for burned parts but found none.
The 20V from the adapter are ok and the battery has 12V if I disconnect the battery plug.
I need the schematic to try to understand where there the problem may be or if it is repairable.
Thanks!