Lenovo IdeaPad 330S-15ARR - 330S_ARR_V06

[AirbusPc]

the clip fails....I think the BIOS is damaged I will use a sop8 I must get it I hope that works

[peste]

Hello, how are you? I update my case, I remove the bios from the board, I have a clamp but when I use the asprogrammer... I have tried several programs, it shows me the memory is zero or empty and when I try to write, it carries out the process as in 4 minutes but when reading again it is at zero... if you know anything I appreciate your help my bios is w25q64fw 1.8v and I use the adapter and clamp thank you very much

remove the bios chip from the board, with the clip you have errors.. or stick wires between the programmer and the chip..

[AirbusPc]

Hello, how are you? I update my case, I remove the bios from the board, I have a clamp but when I use the asprogrammer... I have tried several programs, it shows me the memory is zero or empty and when I try to write, it carries out the process as in 4 minutes but when reading again it is at zero... if you know anything I appreciate your help my bios is w25q64fw 1.8v and I use the adapter and clamp thank you very much

[AirbusPc]

As you wish,
clean the pins sometimes the varnish makes poor contact,
good luck,
my English is not better,
google translate helps me

Ahhaáhh great

[eric paris]

As you wish,
clean the pins sometimes the varnish makes poor contact,
good luck,
my English is not better,
google translate helps me

[AirbusPc]

I don't know
I am not professional
but every time I tried to read an eeprom with the clamp it doesn't work.
I desolder, I clean the pins and it works on the support

i hope not need another BIOS desolder chip AND do it the process again ...thanks AND sorry for muy bad english

[eric paris]

I don't know
I am not professional
but every time I tried to read an eeprom with the clamp it doesn't work.
I desolder, I clean the pins and it works on the support

[AirbusPc]

hello,
desolde the chip it's better

Hi Eric the software said ... Posible enable protect unlock ... ..
Need another spi BIOS ?

[eric paris]

hello,
desolde the chip it's better

[AirbusPc]

I don't want to try to remove the integrated one, I use now the as program v 2.10.13 and ch341a led writing works but when I test the laptop it doesn't show anything waiting 4 or 5 minutes after turning on

[kalilinux25]

Hello, I have problems reading the bios with the ch341a, the software version 1.38 and version 1.34 showed me an initial reading of 1 minute, all in ff, that is, white, and then it tells me that the chip detection fails, my version is 81fb and the bios is w25q64fw 1.8v I use the voltage adapter ahhh and I use the clamp I think the grip may fail although I doubt it... I appreciate your help greetings

you sould try removing the chip , im not a fan of this clips

[AirbusPc]

Hello, I have problems reading the bios with the ch341a, the software version 1.38 and version 1.34 showed me an initial reading of 1 minute, all in ff, that is, white, and then it tells me that the chip detection fails, my version is 81fb and the bios is w25q64fw 1.8v I use the voltage adapter ahhh and I use the clamp I think the grip may fail although I doubt it... I appreciate your help greetings

[AirbusPc]

you need a 1.8v adapater because its a 1.8v chip

Thank you very much for your help...I just confirmed it...

[kalilinux25]

Windbond 1853 25q64fwsiq thanks

you need a 1.8v adapater because its a 1.8v chip

[AirbusPc]

25Q64XXX what is the complete full chip so I can see the datasheet and confirm if its a 3.3v or 1.8v chip

Windbond 1853 25q64fwsiq thanks

[kalilinux25]

I am very new to this I have 330s 15arr 81fb I bought ch341a ...with clamp ...I want to know if I need 1.8v adapter to flash BIOS winbond 1853 25Q64XXX or can I try without the Adapter thanks for the help and sorry for my bad English

25Q64XXX what is the complete full chip so I can see the datasheet and confirm if its a 3.3v or 1.8v chip

[AirbusPc]

I am very new to this I have 330s 15arr 81fb I bought ch341a ...with clamp ...I want to know if I need 1.8v adapter to flash BIOS winbond 1853 25Q64XXX or can I try without the Adapter thanks for the help and sorry for my bad English

[AirbusPc]

thansk for your help

https://articulo.mercadolibre.com.co...7-afdfe8b6d3aa

that function to me case _?

[SMDFlea]

Hello, I have an Ideapad 330S-15ARR (model: 81FB and factory ID: JVHFC1) it does not give video fans on... I try bios update usb but after fn + r for 5 minutes the charging light turns on and off but it does not give no beep , it does not load...... .bin file, how can I access it so that it can load, please help, thank you

You will need to buy an SPI programmer or take the laptop to a repair shop

https://www.badcaps.net/forum/troubl...96#post3304796
https://www.badcaps.net/forum/troubl...post3305259

[AirbusPc]

Hello, I have an Ideapad 330S-15ARR (model: 81FB and factory ID: JVHFC1) it does not give video fans on... I try bios update usb but after fn + r for 5 minutes the charging light turns on and off but it does not give no beep , it does not load...... .bin file, how can I access it so that it can load, please help, thank you