hi all members
can i use a TPS51216 or BQ 727 as replacement of TPS 51716 in DELL INSPIR0N 15-3000
can i use a TPS51216 or BQ 727 as replacement of TPS 51716 in DELL INSPIR0N 15-3000
-
Hello, I'm working on an old Dell XPS410 with burst capacitors. I'm trying to source either an equivalent replacement, or a replacement that will work. It's been suggested to me to use Poly caps as a replacement, but I have no idea what to order or what will work.
If anyone has a link to where I can buy what I need that would be even better.
These are the caps that have burst:
Board location: C8BV, C26BV, C43BV
Brand: United Chemi Con
Series: KZG
Size: 10mm dia X 25mm height
Impedance: (ohms max/20c, 100kHz) .012
Ripple: 2800... -
Hi everyone,
I'm hoping to get some help finding a suitable replacement for the MOSFET EMF30N02J. I'm currently using this component in B450 AORUS M motherboard
Any information or advice would be greatly appreciated!
Thanks, [Issam Seb] -
Hello guys,
I would like a quite old but still good 800 W ATX PSU to be repaired. The problem was an extremely heavy coil whine coming from the small secondary transfomer on the PCB.
I desoldered it hoping the references on the upper side would allow me to find a adequate replacement part. Sadly the written references drove me nowhere but to the manufacturer (I-MAG). I sent them a message like a bottle in the see asking them to send me a datasheet of the transformer. And... They responded ! I received a kind of datasheet (see attachment) but my competencies do not allow... -
Hello,
Not sure if this is the correct section, but I have a PS4 controller that I am trying to fix. It developed stick drift on the left stick and the usual simpler methods did not fix the problem.
So I went on eBay and ordered some replacement potentiometers. https://www.ebay.co.uk/itm/174967976757 is where I got them from.
I took the green potentiometers off the replacement sticks and soldered them onto the PCB. Assembled the controller and ran some tests. The drifting was somewhat fixed (not fully in center, but way better than before). However,... -
This Intersil IC - ISL88550AIRZ on Dell Latitude E6400 (RAM IC) has 19v, but no output - 1.8v. It causes the laptop not to display because of the voltage lacking on the RAM modules. Please, assist me to know the replacement equivalent for this IC. I have two laptops of same make with the same issue. Thanks09-05-2020, 08:04 AM
Comment