Anyone know where are stored Seral and Service Tag parameter on Dell motherboard?
On bios ic there arent that info
On bios ic there arent that info
-
Hello,
this is a very strange Problem:
Notebook hang instantly on Boot. BIOS is accesable.
Windows: instant after showing "loading circle", even Windows Boot Stick hang instant (even without installed SSD/NVME )
Linux: instantly (if Linux Boot in leagacy Mode with log messages: Machine Check exception after 0.25 sec)
i have tried:
- only one RAM Stick, another working RAM, both RAM channel
- BIOS Flash to newest Version F.50, BIOS Reset
- Memtest86 hang instant at Test 2
- HP UEFI Diagnostic wont find... -
I was doing maintenance on my Asus My3604 computer and when I turned it on it did not show an image, a black image, I think it is the bios since it has all the corresponding voltages
I leave the original dump and the series
thank you very much for your help
SN: R5N0CX04D145218
MFD: 2023_05
MOTHERBOARD : M1502YA REV 2.0... -
Hi, sorry if i here to request if anyone know number of pin to set lines for reading ITE7751e on RT809F..i try to see on schematic but i dont know how to choose it..pleasee.. -
Hello and thank you everyone for being here¬!
I really need the Saphire Nitro rx580 8gb Boardview it has a missing VRM So i can work on it
Thank you very much indeed! -
Hi,
Have a storm damaged TV that had a short on the power to IC207 a tiny surface mount near the emmc that still remains after I removed the IC207.
So I got a new mainboard from aliexpress and it all works but I'm wondering if there's a way to transfer calibration data from the old board to the new one or if that's even necessary?
I presume there is some sort of calibration done at the factory??
There are 2 winbond flash ics w25q40cl, w25q80dv and another eeprom 24c512cl.
I tried swapping those to the new board but the TV wouldn't...
Comment