EC part from bios, Where to flash it?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Bradbeat
    Member
    • Jul 2025
    • 13
    • Belgium

    #1

    EC part from bios, Where to flash it?

    Hi everyone,
    Can the EC part of a bios be flashed only on the dedicated chip of the motherboard or must it also be flashed on the main bios chip when there is 2 chips like for example on the LA-G881P motherboard?
    have a nice day.

Related Topics

Collapse

  • Loli Popu
    DELL 5590 LAPTOP DEAD AFTER BIOS WRONG FLASHED
    by Loli Popu
    Hello guys ,i have a dell latitude 5590 with f411p bios,this laptop has bios password ,i tried to read the bios(winbond 25q128jv) with ch341 but when goes to verify give error ,it said doesnt match .After this i flashed another bios which is cleaned and then the laptop was dead ,i tried to turn on but only white light in the buton power turned on several times and then no display at all .I had a backup and flashed again the original bios ,but this time the laptop will not turn on at all ,no light nothing,the bios original bios that i flashed was having verify error when i verified with ch341 ,i...
    12-13-2024, 03:28 AM
  • AkaBukai
    Is it okay to flash stock bios onto the motherboard's BIOS?
    by AkaBukai
    Hi there,
    I have a 14" Lenovo Laptop (Flex 5 14ALC05) which has a boot issue.
    The little LED on the power button is flashing slowly and nothing happen.
    This unit do not have any BIOS button cell battery so I tried many times draining the power but it is still not powering on.

    So I decided to flash the BIOS using a cheap programmer.
    And I was successfully able to read the content (exactly 16MB file) which BTW is a WINBOND 74m12jwsiq (according to the package inscription - but detected as W25Q128FW in the software - IMSProg on Linux)

    I also...
    12-19-2024, 12:15 PM
  • James Jackson
    Panasonic CF-20G0247VM BIOS Bad Flash Help
    by James Jackson
    I usually try to figure these things out on my own but am asking for help now as I have been beating my head against a wall.

    Backstory, I initially ended up with a CF20 Mk2 with a locked BIOS. I used aptio to read the BIOS and made the adjustments to the .rom file and attempted to write it back with aptio before reading other users problems with that setup. Well it bricked the BIOS go figure. Computer no longer boots, black screen. I found a clean BIOS on this forum but now I am having ME issues. So I would rather hand over the aptio dump(pre BIOS brick) and a hardware reader dump(post...
    05-01-2025, 11:28 AM
  • spmetroil
    Request: SPI Flash BIOS Dump (Winbond 25Q128) for Dahua NVR4216-4KS2
    by spmetroil
    Hello,

    I am trying to repair a Dahua NVR4216-4KS2 that is not booting.
    The main BIOS/firmware is stored in an SPI flash EEPROM (Winbond 25Q128, labeled as U130 on the PCB).

    I have a CH341A programmer and I already attempted the following steps:
    1. Identified the correct chip (W25Q128, 3.3V SPI flash).
    2. Tried to read the contents with CH341A Programmer software. The dump seems corrupted and I often get the error: “Chip with the contents are in disagreement.”
    3. Compared several chip type selections (24Cxx and 25Qxx families) to confirm it is indeed a 25 series SPI
    ...
    08-19-2025, 09:23 AM
  • aico60
    Acer Nitro 5 AN515-46 DMI not working
    by aico60
    Hello everyone,

    I am working on an Acer Nitro 5 AN515-46, board HH51R LA-M002P Rev: 1A with an AMD CPU and Insyde Bios rev 5.

    Short issue description: BIOS does not recognize any of the DMI data.

    History of the laptop:
    The seller of the laptop said that it shut down during a BIOS update.
    I bought in in a condition where it turned on but did not post.
    While waiting for my RT809F to arrive, I tried to perform a Crisis recovery, which messed up the EC firmware, so... the laptop stopped even turning on. Power and Charging LEDs didn't work either...
    05-06-2025, 08:44 AM
  • Loading...
  • No more items.
Working...