Hello everyone,
so, the board turns on the white LED when connecting the charger, and turns off quickly. I noticed that when it turns on, it goes up to 3 and 5 V and drops quickly.
A question first of all:
What would be the resistance of the Ryzen processor in this case?
PL 8000, 8001 and 8002 are at 2.1 Ohms, is that correct?
I don't have 3V on pin 96 PM_RSM_RST# of the EC nor on pin 14 O_RST_EC# and I also don't have a short on these lines.
On the EC I only have +3VA on pin 12.
On the pins where +3VA_EC should go I have nothing.
I have already reflashed the main BIOS, but I couldn't read the EC through SVOD3, I believe it is not being powered.
Is the lack of this +3VA_EC voltage right?
I thank all my colleagues in advance!
so, the board turns on the white LED when connecting the charger, and turns off quickly. I noticed that when it turns on, it goes up to 3 and 5 V and drops quickly.
A question first of all:
What would be the resistance of the Ryzen processor in this case?
PL 8000, 8001 and 8002 are at 2.1 Ohms, is that correct?
I don't have 3V on pin 96 PM_RSM_RST# of the EC nor on pin 14 O_RST_EC# and I also don't have a short on these lines.
On the EC I only have +3VA on pin 12.
On the pins where +3VA_EC should go I have nothing.
I have already reflashed the main BIOS, but I couldn't read the EC through SVOD3, I believe it is not being powered.
Is the lack of this +3VA_EC voltage right?
I thank all my colleagues in advance!
Comment