Asus ROG Ally - Super IO Chip replacement

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ongobongo
    Senior Member
    • May 2023
    • 62
    • Germany
    #1

    Asus ROG Ally - Super IO Chip replacement

    Hello everyone,
    anyone here who has experience with replacing the super IO chip of an ROG ally?
    I have one on my bench which has a burnt super io (ITE 5125VG-192). On some devices the super-io downloads it's firmware from BIOS if it's empty. As i don't have a programmer for this chips i hope someone here has already changed the chip and can give me a hint if it's working with an empty chip if it needs external programming.
    Thanks
    Ongo
    Tags: None
    • ongobongo
      Senior Member
      • May 2023
      • 62
      • Germany
      #2
      a small update: I ordered a new, pressumably empty EC chip. After desoldering the old one, the problem (1.8ohm short on a cap near ec chip and 3.3v ldo line only providing 2.7V) went away. so I'm pretty confident that the old ec chip was burnt and was the problem.
      however, after soldering the new ec chip nothing happens. meter shows solid 20V with 0A current consumption. On the board, only the 3.3V ldo seems to be active, with a derived 1.8V for powering the Bios. Coils look fine ohms-wise, no suspicios shorts.
      any ideas where to look next?

        Comment

        • mcplslg123
          Badcaps Legend
          • Jun 2015
          • 7262
          • india
          #3
          Yes, i've replaced IT5125VG on asus ROG motherboard and it doesnt needs programming. It will program itself orst power on. Soldering this type of SIO requires good skill.A slightly higher temp on hot air gun may damage the SIO.
          Aligning it perfectly on the mb is another challenge. Are you sure you soldered it correctly and no pcb trace was damaged during cleaning?

            Comment

            • ongobongo
              Senior Member
              • May 2023
              • 62
              • Germany
              #4
              Thanks for the heads-up mcpisig123. I hadn't had a problem with soldering BGAs for ages but i took your advise serious. just desoldered, reballed and re-soldered the ec-chip but still no change of problem. Maybe i really am unlucky with the chip itself, that would be a bummer :-( I decided to check the bios, maybe it got faulty by the same fault that destroyed the original ec chip. I just read it and will ask the forum to check it as I have no clue what to look for when it comes to bios
              keep you posted

                Comment

                • mcplslg123
                  Badcaps Legend
                  • Jun 2015
                  • 7262
                  • india
                  #5
                  Was the SIO chip sourced from reliable vendor? A lot of fake chips has flooded the market.

                    Comment

                    • ongobongo
                      Senior Member
                      • May 2023
                      • 62
                      • Germany
                      #6
                      bought it from ali express from a vendor i bought a lot of stuff from the last month/year, so I'd say it's as good as it gets

                        Comment

                        • ongobongo
                          Senior Member
                          • May 2023
                          • 62
                          • Germany
                          #7
                          In case this might help people in the future:
                          The EC-Chip on the ROG ally does indeed programm itself and doesn't need to be programmed ahead of installing. Had some annoying other issues with my console which pointed to a not working EC-chip but where actually just diversions.

                            Comment

                            Previous template Next

                            Related Topics

                            Collapse
                            • hayezy09
                              Asus rog ally, no charge issue relating to the ite super io chip
                              by hayezy09
                              Hows it going just wandering if anyone has had any luck repairing rog ally’s no charge issue relating to the ite super io chip, swapped out two of these chips i bought off two different sellers on aliexpress and still no luck, both devices power on from battery but will not charge, cant find any kind of definitive answer online on wether they need to be programmed or not, either they do need to be programmed or the chips i have are no good was just wandering about anyone else’s experiences with repairing this paticular problem, cheers.
                              10-09-2025, 12:12 PM
                            • ebugs
                              Asus laptop EC/SIO chip replacement
                              by ebugs
                              Asus Vivobook 15 (board X513ea R2.0) gone dead when user plugged an iPhone cable into the USB-C port during boot. Now there's no LED light, no power at all. I checked all MOSFETs and capacitors, no shorts found. The board only has 3.3V and 5V present, no other voltages.

                              I injected 3.3V into the EC chip power rail (ITE IT5125VG 128), and it draws 80mA, while the 3.3V LDO chip RT8249C has a max output of 100mA. I checked the boardview and found there are only two chips on this 3.3V rail, EC and Realtek audio chip. So I think EC could be the problem.

                              I found the EC chip...
                              09-14-2024, 02:09 AM
                            • BMCappelletti
                              Asus Chromebox CN62 - wrong chip put on BIOS reader
                              by BMCappelletti
                              Long story short:
                              - dad converted Asus Chromebox CN62 into Windows compatible, with mrchromebox BIOS, years and years ago
                              - gave the computer to his son a couple years later
                              - son now decided to revert it to Chrome OS, to sell it as original (re-writing BIOS with the backup one created by his dad)
                              - too lazy to remove the board from the case, thought a voltage regulator was the BIOS chip (you know... it has 8 legs)
                              (seems like the story was not that short)

                              He used alligator clips to read the chip. No luck reading it. Removed chip and placed on a SOC-8...
                              01-08-2025, 07:27 PM
                            • DynaxSC
                              ASRock B650M PRO RS - BIOS CHIP 25Q256JW BLOCKED BY STATUS REGISTERS
                              by DynaxSC
                              Hi

                              I have a very strange issue with the BIOS SPI chip of an ASRock B650M PRO RS motherboard.
                              The SPI chip is an Winbond 25Q256JWEQ model (1V8).
                              The motherbaord doas not POST - it lits only CPU and DRAM EZ Debug Leds, and stays that way forever.
                              The Flashback function of the motherbaord is also not working, despite all instructions followed correctly - I'm 100% sure of this.

                              I have then desoldered the chip, backupped the contents, and tried to earease the chip in order to program stock image, but the chip is locked by status registers SREG2 (TB) and SREG6...
                              08-04-2025, 12:20 PM
                            • Agx03
                              Please help me identify this chip. Asus ROG Ally Z1 Extreme
                              by Agx03
                              This is found between the usb-c port and processor of a Asus ROG Ally Z1 Extreme. I cannot find it anywhere on google. Please help me identify....
                              06-15-2025, 11:27 AM
                            • Loading...
                            • No more items.
                            Working...