Packard Bell Easynote NJ65-AU-003ACb

[glicos]

Good days Guys,

Currently i have for repair a Packard Bell Easynote model NJ65. Symptom is dead (not powering up). When pressing power button, the power indicator just blink and nothing happens (power adapter is connected). Initial check indicate 19V output on AC adapter (twisting end cable still output 19V indicating a working AC Adapter). Hoping others encountered the same model with the same symptom. Any help is highly appreciated. Will post the PCB here one i open up this laptop. Will update this thread..thanks for any input!!

[glicos]

Re: Packard Bell Easynote NJ65-AU-003ACb

Here are the motherboard pics of the said notebook:







Hope anyone here can share a schematic for this motherboard. BTW, the Power Management Chip used is Intersil ISL6266A

[atsio]

Re: Packard Bell Easynote NJ65-AU-003ACb

[glicos]

Re: Packard Bell Easynote NJ65-AU-003ACb

Thank you very atsio. Is this still valid since in the schematic, it says rev 1a but in the PCB revD? Anyway i assume this is still ok..its just a revision...

[atsio]

Re: Packard Bell Easynote NJ65-AU-003ACb

This is the discrete version. You have the UMA version. This will probably not be a problem because you probably have a problem on power and not graphics.

I should start by checking PQ33 and PQ1.

[glicos]

Re: Packard Bell Easynote NJ65-AU-003ACb

This is the discrete version. You have the UMA version. This will probably not be a problem because you probably have a problem on power and not graphics.

I should start by checking PQ33 and PQ1.

Thanks atsio..im now on it i will post the result of my endeavor...with pictures if i can...