i need little help here, and thnx to all who have helped me, mboard: DABKLIMBAC0
but the issue is laptop was dropped and i think the pch solder ball was cracked because when i press pch with finger it boots up and works, but it heats up sometimes and shuts down bc i cant keep my finger on it, i think under pch is small piece of solder rollin and shorting stuff, sometimes it wont heat but still shuts down when i take pressure off
should i remove plastic things on corners of pch and flow flux under it, and flush it with flux & hot air gently and after that do reflow from under mboard to pch, i dont have skill to remove it and reball
but the issue is laptop was dropped and i think the pch solder ball was cracked because when i press pch with finger it boots up and works, but it heats up sometimes and shuts down bc i cant keep my finger on it, i think under pch is small piece of solder rollin and shorting stuff, sometimes it wont heat but still shuts down when i take pressure off
should i remove plastic things on corners of pch and flow flux under it, and flush it with flux & hot air gently and after that do reflow from under mboard to pch, i dont have skill to remove it and reball
Comment