Hi all,
For polymodding an original Xbox i'm looking for polymer replacements of the following capacitor:
2x 10v 3300uf Nichicon PW
One is on the left side of the board, the other one on the right as you can see the picture i linked below (the two big brown caps).
Could i just use 2200uf polymers to replace them or do i really need the capacitance?
I have searched the forum already but could not find an answer for it.
Thanks.
For polymodding an original Xbox i'm looking for polymer replacements of the following capacitor:
2x 10v 3300uf Nichicon PW
One is on the left side of the board, the other one on the right as you can see the picture i linked below (the two big brown caps).
Could i just use 2200uf polymers to replace them or do i really need the capacitance?
I have searched the forum already but could not find an answer for it.
Thanks.
Comment