Hey guys, first let me say that this forum is awesome. I've already managed to fix 6 cards in a short amount of time with the info on here. The issue I'm having now, is I have a Sapphire nitro plus rx580 with a dual bios. The switch and the pads go ripped off the board, and I've had absolutely no luck following the trace(s). I've gone over all the schematics I could find, but none have the same component numbers. This has been driving me nuts!
Edit: from the schematic I've been reading (assuming I'm reading it right), gpio 10 romcs pulls the ce pin low via a 20k ohm to ground. Is that all I'd need to do is solder a 20k resistor on the ce pin and to ground? I don't care about having a dual bios, I have a t48 programmer, but I really have no intention of flashing the bios
Edit: from the schematic I've been reading (assuming I'm reading it right), gpio 10 romcs pulls the ce pin low via a 20k ohm to ground. Is that all I'd need to do is solder a 20k resistor on the ce pin and to ground? I don't care about having a dual bios, I have a t48 programmer, but I really have no intention of flashing the bios
