MSI MEG Godlike x570 motherboard - need schematic and boardview. I have accidentally plugged in the wrong usb plug into a usb3.0 connector on front panel of PC resulting in temporarily shorting out the port. (I know it was really stupid, It was dark in my room and was rushing). I shutdown the computer and now after an immediate restart I get an overcurrent error on boot up saying my PC will shut down in 15 seconds. If I let the computer sit for about 35 minutes, I then can boot the PC without getting error. What I am hoping to find out is what parts were affected by my stupidity. Anyone have any insight into this? I dont believe my problem has anything to do with bios corruption as I have seen online in some posts talking about this error. Please help. Thanks.
-
-
there is 6pin ic near every usb port on board. remove that near your problematic usb port -
Thank you for this info. Do you happen to know what the proper part number is so I can replace it? Is it a usblc6-4sc6 per chance?Comment
-
Check your board. Next to the usb 3.0 header there will be multiple "multi legged" components (esd filters).
One-or multiple of them got shorted. You can measure them, only one or two of its leg should be shorted to ground. In case if one of em is burned out, you can still read the part number on the other one, cause they are the same.
I only have schematic for the x570 gaming pro carbon. It is using these eight legged variants.
Datasheet: https://www.aosmd.com/res/datasheets/AOZ8829DI-03.pdf
Correction:
*eight legged = ten leggedComment
Comment