Ubiquiti Powerbeam Ac Gen2 Pbe-5ac-gen2 bridge not working

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CapLeaker
    Leaking Member
    • Dec 2014
    • 8132
    • Canada

    #1

    Ubiquiti Powerbeam Ac Gen2 Pbe-5ac-gen2 bridge not working

    I've got a Wifi bridge setup with two Ubiquiti Powerbeam Ac Gen2 Pbe-5ac-gen2 450 Mbit/s units. They ran great for 18 months and are about 2km apart, line of sight. Last week sometime they somehow disconnected from each other and will in the world not reconnect. I looked at the config on both units and surely they aren't paired anymore for one reason or another. I tried a site scan to see other unit but I cannot see it trying to marry them back together.

    I rebooted both units
    Tried to look for the others signal, but it's not there.

    I've set up a few Wifi bridges, but this is the first one that came undone somehow.

    WTF???
  • CapLeaker
    Leaking Member
    • Dec 2014
    • 8132
    • Canada

    #2
    Re: Ubiquiti Powerbeam Ac Gen2 Pbe-5ac-gen2 bridge not working

    Here is the fix.
    Did a factory default followed by a firmware upgrade on both units. Then reconfigured the bridge from scratch with the same parameters I had before. Works like a charm again!

    Comment

    Related Topics

    Collapse

    Working...