Friend asked me to look at this but all but 1 caps look ok [all are GSC except the one slightly iffy looking fuhjyyu]
The inverters/tubes are working fine however no display appears unless you repeatedly turn it on and off.
I changed the 100uf 400v fuhjyyu mains cap out for another i had kicking around but on reasembly and testing i discovered that without fail, if i remove and reinsert the screen ribbon cable the display comes on perfectly.
In this state the monitor works flawlessly untill the next power cycle.
Do i continue to look in the psu area or is it as i suspect, the logic board that is hosting the fault?
The inverters/tubes are working fine however no display appears unless you repeatedly turn it on and off.
I changed the 100uf 400v fuhjyyu mains cap out for another i had kicking around but on reasembly and testing i discovered that without fail, if i remove and reinsert the screen ribbon cable the display comes on perfectly.
In this state the monitor works flawlessly untill the next power cycle.
Do i continue to look in the psu area or is it as i suspect, the logic board that is hosting the fault?
Comment