Hi guys,
Got 2 of these monitors, swapped the inverter board over on them both to confirm that this is the part with the issue.
I am about to replace the 10 35V 100uf capacitors. But i am also under the impression i should check the fuses.
In the photos below i can only see 3 fuses F1, F2 and F3. How do i check these with a mutli meter? Do i simply turn the multimeter to a resistance measurement and then place the probes either side of the fuse? Do i need to desolder them from the board first? What setting do i use on the multimeter, the options i have are 2000k,200k,20k,2000 and 200?
Many thanks
Got 2 of these monitors, swapped the inverter board over on them both to confirm that this is the part with the issue.
I am about to replace the 10 35V 100uf capacitors. But i am also under the impression i should check the fuses.
In the photos below i can only see 3 fuses F1, F2 and F3. How do i check these with a mutli meter? Do i simply turn the multimeter to a resistance measurement and then place the probes either side of the fuse? Do i need to desolder them from the board first? What setting do i use on the multimeter, the options i have are 2000k,200k,20k,2000 and 200?
Many thanks
Comment