Onkyo TX-NR616, constantly clicking, no display, no light/led

[lcdcaps1]

Re: Onkyo TX-NR616, constantly clicking, no display, no light/led

if it worked before apart from the hdmi best i can suggest is putting everything back to how it was then see if it is back to square one .

Thanks for the reply

I read on another forum it is due to certain components failing ..
So I replaced those bits but no change as mentioned in the link in the link i posted

I've been reading the forums and reading allot .
Some people have had similar issues and it has been the thermal fuse but I don't think it is this because I have few ohms across the primary side of the transformer but i am confused which wires are the thermal fuse wires but there is continuity between all the wire

The other thing I read is it could be a grounding problem.
I Did not put the screws back that go into the hdmi board and the power supply board is held by top screw only .
Can this be the problem .

The other thing I read is the the cable coming from the power supply board to the hdmi board is not seated properly
I have checked and checked but makes no difference.

Will adding the screws that secure the hdmi board to the chassis and the screw that secures the hdmi board to the board on the right, not sure what board it is plus the power board screw that secure it to the chassis make a difference

Please can you help me .
Thanks so much

[petehall347]

Re: Onkyo TX-NR616, constantly clicking, no display, no light/led

if it worked before apart from the hdmi best i can suggest is putting everything back to how it was then see if it is back to square one .

[lcdcaps1]

Re: Onkyo TX-NR616, constantly clicking, no display, no light/led

Hi
Please can anyone help me

[lcdcaps1]

Hi
I have an Onkyo TX-NR616 that has is constantly clicking when I plug it into the mains
I can hear the relay clicking but also the transformer is vibrating not sure why

I have tried with all the ribbon cables connected and with just JL901B connected but same symptoms
I have tried with fan and no fan

I have followed this thread

repairalmostanything.com/thread/790/onkyo-relay-constantly-clicking-txnr

I have replaced the components mentioned on this thread with hope that it will turn on but with no success
I am a novice when repairing Amplifiers but know a little about electronics but always wanting to learn more
This is My own Amplifier and is well looked after like a baby

I had to open because I needed to check for leaking caps as I was not getting any HDMI output
Please can someone help me fix this. I will be so grateful and will appreciate it so so much

There are allot of talented people here so I look forward in getting to know you all and