Service manual for Teac A-X550?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Xenon-Codex
    Senior Member
    • Jan 2018
    • 183
    • Finland

    #1

    Service manual for Teac A-X550?

    This seems to be hard to find. Does anybody have it or the schematic? A-X400 uses the same manual.
  • petehall347
    Badcaps Legend
    • Jan 2015
    • 4426
    • United Kingdom

    #2
    Re: Service manual for Teac A-X550?

    doubt you find it .. teac tascam are very secretive and dont want you fixing things .well thats the attitude i got with them .

    Comment

    • stj
      Great Sage 齊天大聖
      • Dec 2009
      • 30991
      • Albion

      #3
      Re: Service manual for Teac A-X550?

      https://elektrotanya.com/showresult?...at2=all&page=2
      some possibly similar stuff

      Comment

      • Xenon-Codex
        Senior Member
        • Jan 2018
        • 183
        • Finland

        #4
        Re: Service manual for Teac A-X550?

        Thanks, the A-X55 looks quite same.

        Comment

        • Xenon-Codex
          Senior Member
          • Jan 2018
          • 183
          • Finland

          #5
          Re: Service manual for Teac A-X550?

          The replacement part arrived, but it does not work. Is there any way to get 7-pin RK14 50KC potentiometer for the bass-control? Everything else is available, but this reverse-audio taper(?) is not. The old has cracked taper which is not repairable.
          Replacement part is acting weirly, if I turn bass to minimum, volume goes to max. It's supposed to be an 50K audio taper, but apparently without the C. It does affect correctlyu to the bass level in the max end.

          Comment

          • Xenon-Codex
            Senior Member
            • Jan 2018
            • 183
            • Finland

            #6
            Re: Service manual for Teac A-X550?

            I ordered two more pots, and again the first one was not working. It appeared to be broken(!). But the second works, after I cut the metal part so it would fit to the hole... 3mm needed to be cut.
            Attached Files

            Comment

            Related Topics

            Collapse

            Working...