One of my 360s was slowing down/freezing so I did a thermal compound replacement on it.
Long story short, when refitting the fan shroud, I tore one of the components off. Frankly I blame M$'s awful board design, since Y381 is literally right next to where it swings open, but hey.
Y381 is detached with the pad completely ripped off on one side (ignore the blu-tack). C386 is also detached but you can't tell from the photo, and I can't see whether it has lifted a pad or not. At the present moment in time this board does not power on.
What is the best way forward with this? bridge Y381's lifted leg to C387 and fire some hot air at C386? This soldering is way smaller than I'm used to :/
Cheers
Long story short, when refitting the fan shroud, I tore one of the components off. Frankly I blame M$'s awful board design, since Y381 is literally right next to where it swings open, but hey.
Y381 is detached with the pad completely ripped off on one side (ignore the blu-tack). C386 is also detached but you can't tell from the photo, and I can't see whether it has lifted a pad or not. At the present moment in time this board does not power on.
What is the best way forward with this? bridge Y381's lifted leg to C387 and fire some hot air at C386? This soldering is way smaller than I'm used to :/
Cheers
Comment