ive got a couple of computers here that i am thinking of either recapping with rubycon/etc or partially or fully polymodding. first of all i have a Dell GX520 "Toaster" SFF PC that i use as a backup whenever i have problems. i figure as its put under a lot of thermal stress a polymod and cooling mod might be useful considering i do end up using it a bit. the second board is a Second Hand DG35EC that i use as a server so its up pretty well 24-7. ive been having problems recently with the intergrated X3500 GPU Drivers resetting and was thinking about taking the system down and having a look as i kinda cannot afford it to randomly break. do you think it is worth even recapping these systems or should i just wait till a fault pops up and then fix it later.