Help identifying a SMD component.

[Spork Schivago]

Re: Help identifying a SMD component.

I will include a picture of the surrounding area. I did not see any reference designators though on the PCB. I hope this is enough area. If not, let me know, I will take another picture zoomed out a bit. Thanks.

[Wrog]

Re: Help identifying a SMD component.

Can you include a picture of the surrounding area? Maybe there are reference designators that might give an indication of what they are...

[Spork Schivago]

Hello. I am working on an effect pedal for a guitar. I wasn't sure if I should of posted this in the audio troubleshooting / installation forum or here. I figured since I don't need any help in troubleshooting what's wrong with the pedal, I would post it here. I apologize if this is in the wrong place.

The owner used a transformer that was rated for a higher voltage than the pedal needed. He fried a component on the PCB. The fried component kind of exploded a bit and burned off all the markings. After spending some time, I've come to the conclusion that there are three other components of the same type on the board. I am having trouble identifying them.

They are blackish in colour and have a white and yellow band on them. I believe that the white band might be the cathode side and not a band per say. If I test the working components as diodes and have the black probe on my DMM on the side with the white mark, it shows a reading of some wheres around 5.6 Mohm's. If I switch the probes, I get O.L.

Can some one help me identify these and perhaps find a place that sells them? I cannot find anything on the net. I am attaching a picture of the components. Thanks.

Spork Schivago