Hello. I Have an EZP2019+ Programmer with an assortment of adapters that I am trying to use to dump the original BIOS firmware from a MICRON 25Q128A IC (Datasheet here) and then flash the newest BIOS firmware.
I have the chip de-soldered from the motherboard and have the chip fitted securely into the "200-209mil SOP8 Socket" adapter. This adapter is placed into the top portion of the 1.8V adapter and that] adapter is connected to the top portion of the programmer.
It doesn't seem like the software is able to read the chip:
Since the datasheet says this is a 1.8V chip, I have it connected in the 1.8V adapter socket. Here is my setup:
Am I doing this right? Why can't it read the chip?
I have the chip de-soldered from the motherboard and have the chip fitted securely into the "200-209mil SOP8 Socket" adapter. This adapter is placed into the top portion of the 1.8V adapter and that] adapter is connected to the top portion of the programmer.
It doesn't seem like the software is able to read the chip:
Since the datasheet says this is a 1.8V chip, I have it connected in the 1.8V adapter socket. Here is my setup:
Am I doing this right? Why can't it read the chip?
Comment