So I picked up a known not working SGI MLA adapter for a 1600SW SGI panel (I know this works, tested on a SGI O2) a few weeks ago. The adapter lets you use a 1600SW panel with DVI input.
The guy I got it from was going to chuck it in the bin but I thought I'd see if I could see anything wrong on the pcb as usually these suffer from blown mosfets. The mosfets appear fine and unit powers on but produces a solid red status led.
There was however a dodgy looking three-legged component (suspect a paired diode?) that looked like it's coocked. The plastic package has burnt and bulged in the middle. I can only make out a 'Z' on the left of the package.
Any ideas how to obtain the specs of this component or source a replacement?
Thanks in advance.
The guy I got it from was going to chuck it in the bin but I thought I'd see if I could see anything wrong on the pcb as usually these suffer from blown mosfets. The mosfets appear fine and unit powers on but produces a solid red status led.
There was however a dodgy looking three-legged component (suspect a paired diode?) that looked like it's coocked. The plastic package has burnt and bulged in the middle. I can only make out a 'Z' on the left of the package.
Any ideas how to obtain the specs of this component or source a replacement?
Thanks in advance.
Comment