Something unfortunate happened recently when I was looking into my InterTan monitor after the On/Off switch stopped latching. I was going to put a cable tie round it to keep in turned on at the switch perminantly and just turn it on & off at the wall. But I dropped the end out of my screwdriver into the open monitor when it was turned on. It fell down by the on/off switch and I would guess it must have shorted the Live & Neutral wires that are right beside it. It did pop the fuse but it just pops a new fuse if I put one in so somethingelse is blown as well.
Not sure what make this monitor is but I bet its not Tandy made. Anyway I have uploaded a whole lot of photos of it here for you to see.
https://drive.google.com/open?id=1ZA...OHIe7UWmJDOvmS
I have it stripped on my bench and so far all diodes I have checked including the one right near the Switch are OK.
https://drive.google.com/file/d/17M5...ew?usp=sharing
I would really appreciate if someone please help me track down what it is I have popped as I really need this monitor and I feel so stupid now for leaving it opened up while it was turned on.
Not sure what make this monitor is but I bet its not Tandy made. Anyway I have uploaded a whole lot of photos of it here for you to see.
https://drive.google.com/open?id=1ZA...OHIe7UWmJDOvmS
I have it stripped on my bench and so far all diodes I have checked including the one right near the Switch are OK.
https://drive.google.com/file/d/17M5...ew?usp=sharing
I would really appreciate if someone please help me track down what it is I have popped as I really need this monitor and I feel so stupid now for leaving it opened up while it was turned on.
Comment