Hi there, I'm trying to fix an issue with my washing machine (Whirlpool AWG865) and its control board, namely a MINISEL 600 85SX-85DX-45DX (attached photos). The issue started with the machine refusing to accept a change in the washing cycle selection, it was stuck in cotton 60c and turning the potentiometer on the front wouldn't change the selection. Then after a few days in this condition it began to get high water temperatures and the board got a little charred near R54. I'm at a loss here, I did try to test some of the obvious components (capacitors, diodes, triacs...) but couldn't find a thing, maybe the culprit is the MCU?
To be honest repairing this board is nothing more than a challenge now that I've got a new machine, it's just the idea of getting screwed by a little resistor or cold solder joint that bothers me... Any guesses much appreciated.
To be honest repairing this board is nothing more than a challenge now that I've got a new machine, it's just the idea of getting screwed by a little resistor or cold solder joint that bothers me... Any guesses much appreciated.
Comment