So I have this 8 year old DLP. It has two CapXon LP's that are surprisingly in series. Ive seen most of these in parallel on most power supplies. This hooks directly to the lamp ballast, that has a bloated cap I replaced. It bloated after I recapped it with a Panasonic EE. I'm assuming this was because of the dried out capXon LP's
getting replacements have been difficult, as almost all 200v 470u has been rated at 2.2Arms. Highest i've seen at mouser have been like 1.8Arms
what margin of error do I have here? Would these POS's actually be rated @ 2.2A out of the factory, being that they're capXons?
getting replacements have been difficult, as almost all 200v 470u has been rated at 2.2Arms. Highest i've seen at mouser have been like 1.8Arms
what margin of error do I have here? Would these POS's actually be rated @ 2.2A out of the factory, being that they're capXons?
Comment