Hello, I have this sub notebook. I5, 8Gb soldered, build in 2019.
It has a very little water damage in processor power driver zone: I easyly removed superficial oxidation with thootbrush and the board is very clean. And I don"t yet cleaned with flux. 4 caps still have traces but no true damage and no short.
I measured 5 Ohms at some pins around the driver chip.
From your experience, it is normal around this kind of chip pls ?
The true problem is maybe that I don't found any issue, no true short anywhere. I don't know if the board works or not, and I'm scared to power on for testing. Thx.
It has a very little water damage in processor power driver zone: I easyly removed superficial oxidation with thootbrush and the board is very clean. And I don"t yet cleaned with flux. 4 caps still have traces but no true damage and no short.
I measured 5 Ohms at some pins around the driver chip.
From your experience, it is normal around this kind of chip pls ?
The true problem is maybe that I don't found any issue, no true short anywhere. I don't know if the board works or not, and I'm scared to power on for testing. Thx.
Comment