Lenovo P50 power-on issue

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • palady
    Member
    • Jan 2014
    • 20
    • si

    #1

    Lenovo P50 power-on issue

    Hi,

    Lenovo P50
    MB: BP500, NM-A451, VER 1.0

    Issue: won't start. Power LED turn on for 1 sec.
    I check rails, they're all work a short time, looks fine. Only GPU reg. is silent. EN pin is 0V.
    I didn't find any shorts corrosions, mechanical demages, etc. Any sugestion?

    I hope the CPU is not dead

    Schematic and boardview -> https://www.badcaps.net/forum/troubl...96#post3242496

    Last edited by Vesko356; 03-26-2024, 06:14 AM. Reason: Attached schematic and boardview removed and replaced with link
  • piernov
    Super Moderator
    • Jan 2016
    • 4435
    • France

    #2
    Re: Lenovo P50 power-on issue

    CPU VCore ok?
    Tried known good compatible RAM?
    Tried to flash the BIOS?
    OpenBoardView — https://github.com/OpenBoardView/OpenBoardView

    Comment

    Related Topics

    Collapse

    • db80
      Lenovo Ideapad 5 15ARE05 startup issue
      by db80
      Hello friends,

      I've been racking my brain over the past few months on the following issue:
      I have a Lenovo Ideapad 5 15ARE05 laptop that basically works fine as long it starts up at all.

      If you shut it down, often you hear the HDD still spinning and the Power LED remains on, it only shuts down if you force it (pressing the power button for like 15 seconds).
      Then, if you want to Switch it on, nothing happens, only the Power LED lights on, nothing else. If you leave it, then after like 30-60mins it turns on itself.
      I tried all the common alleged „fixes“...
      07-06-2024, 05:58 PM
    • code share
      Lenovo P43s won't boot with internal battery connected – looking for help diagnosing battery issue
      by code share
      Hi everyone,

      I'm having an issue with my Lenovo ThinkPad P43s. The laptop does not power on when the internal battery is connected, but it works fine on AC power alone (battery disconnected). Once the battery is reconnected, the system becomes completely unresponsive — no lights, no fan spin, nothing.

      Here's what I've tried so far:
      • Power/EC reset (held power button for 60 seconds with battery and AC disconnected)
      • Booted successfully on AC power only with the battery disconnected
      • Visual inspection of the battery — no swelling, burn marks, or connector damage
      • Battery
      ...
      04-21-2025, 12:50 PM
    • Nagyesz
      Lenovo ideapad 3 15IL05 - ram issue
      by Nagyesz
      Hi all,
      I've encountered an issue I've never experienced before..

      The Lenovo works perfectly, it has 4gb soldered ram and an additional slot. With just the 4gb the laptop passes all tests, everything is working. However no matter what frequency or capacity of ram I add to the extra slot the display starts artifacting completely randomly in both in the bios and in win and the only solution is to shut down.

      I've inspected the pins of the extra slot with a magnifying and didn't notice anything unusual. I've also tried multiple ram modules, but the issue is the same....
      01-11-2025, 05:17 AM
    • dal00
      Lenovo ThinkPad X1 Carbon Gen6 (NM-B48) Thunderbolt issue
      by dal00
      Hi!

      My Thinkpad X1gen6 (NM-B48) have had issues with thunderbolt for over a year now. No TB3 or HDMI working and the screen randomly flickering sometimes but going away other times. As if there was a glitch in the connection.

      When it was starting to fail I switched between assist mode and the non assist mode a lot because I didn't understand what was going on and some times it helped. (but really it probably made it worse by writing more to the flash) At one point when it had failed a switch like that hung the laptop with a black screen and I had to hard reset. That...
      09-07-2022, 08:27 AM
    • Pfudaniel
      reading EC with svod4 Lenovo NM-D271 issue
      by Pfudaniel
      Hello, im trying to read the EC of lenovo NM-D271 butthe files come up empty after read.
      Im using pinout provided from online database made by Adytia.

      Pin detection is succesfull and i read in 384 size.
      I was hoping to have some help to get the EC read succesfully. might be a pinout issue ? if anyone got more info on this id love to hear it.

      Thanks.
      03-29-2025, 03:04 AM
    • Loading...
    • No more items.
    Working...