Rec'd this card - dead.
In fact, most of the SMT poly caps topside had been removed.
As it appears all of these have been removed with force,
two of the caps have lifted the foil on the pcb.
This isn't so bad - I can pop in some Pana FM to replace
these in order to test go/no go.
What I don't have (as it was missing) was the powerlead for
the heatsink fan. I would like to ID this in order to obtain.
This is a 3 pin type.
The HSF end has a smaller connector than the board end.
In common with these types of connectors, they are keyed
to go in one way only.
Can any members help?
In fact, most of the SMT poly caps topside had been removed.
As it appears all of these have been removed with force,
two of the caps have lifted the foil on the pcb.
This isn't so bad - I can pop in some Pana FM to replace
these in order to test go/no go.
What I don't have (as it was missing) was the powerlead for
the heatsink fan. I would like to ID this in order to obtain.
This is a 3 pin type.
The HSF end has a smaller connector than the board end.
In common with these types of connectors, they are keyed
to go in one way only.
Can any members help?
Comment