Hey folks,
If I wire the chip to the RT809HSE as described in the first post and wire the board with power, I cannot read out the chip. If I reverse the wiring completely and disconnect the power, I can read the chip, but I always get a “Chip verification error, start Position: 0x0.” and cannot delete the chip.I soldered in the 10k resistor, but left the old resistor in its old place. Any ideas?

Mec1663-ba0
t480s

edit: disabling auto verification lets me read and save a dump but erasing won't work ("Chip is not blank, start position: 0x0.")