Re: asus p5ld2 w/ kzg

A big thanks to everyone who helped me out. I'll drop a comment if these new caps fix my board. Thanks!

Re: Dell XM091 (PowerEdge 840) - Help identify caps

Thanks everyone!!! I really appreciate it.

Re: Dell XM091 (PowerEdge 840) - Help identify caps

Excellent! I just ordered these:
[url]https://www.badcaps.net/store/product_info.php?cPath=3&products_id=37[/url]

The motherboard has 3 of these... one of them was bulging out and oozying out of the top.. the other two looked ok but I figured I'd replace them since they are the same kind of caps.Re: Dell XM091 (PowerEdge 840) - Hel...> <br /> The

I was wondering if you guys could help me identify these bad caps and tell me what I should replace them with.. :/ I've attached two pictures of each side of the cap to help provide as much info as possible....

Re: asus p5ld2 w/ kzg

Dude, ABSOLUTELY NO need to apologize! I had a nasty flu for almost a month so I know what it's like.

If everyone else seems to agree, I will be ordering the caps that yyonline has mentioned. I value everyone's opinion very much and I really appreciate the help. I just want your blessings before I pull the trigger.

Re: asus p5ld2 w/ kzg

pfrcom: Yes, the little ones are in fact Panasonic FJ. I see the little FJ on the side and the stylish "M". Since they are not bulging, and are Panasonic's, I suppose I wont replace them. I do want to replace the 1500uf KZG's though since they are bubbly on the top.

kc8adu: I don't have any blue caps near the HS/F area.

c_hegge: Thanks for clarifying. I will be purchasing the following item to replace my 1500 KZG's once you guys verify the diameter...
[url]https://www.badcaps.net/store/product_info.php?cPath=3&products_id=39[/url]...

Re: asus p5ld2 w/ kzg

Sorry to revive such an old thread, but I haven't found anything else on the web about bad caps on an ASUS P5LD2 board. I also have this board, and have a few bulging caps. I am guessing that this is why my board fails to give post or any audible errors. After some testing, it appears that all my other hardware is working properly. The caps that I see with convex surfaces are labeled KZG 6.3V 1500UF. They are different from the ones that user iamspuzzum is referring to, but are the same brand and I see that you guys have seen problems with these KZG's before....