jaglion19
Senior Member
Last Activity: Today, 10:03 AM
Joined: 10-03-2017
Location: ANKARA
-
I tried this first, but the flash image tool wouldn't let me install it, even though they were the same ME versions. I also think the CSE region partitions wouldn't work either. If that worked partially, I thought I could update it from the BIOS.... -
I searched the entire system just to help. If I could find a 32mb ice like bios, I would fix it, but there is none
...
Leave a comment:
-
Try this as well. If it doesn't work, the problem is most likely not with the BIOS. If it works, you should change the service tag in the asset tag section of the BIOS....Leave a comment:
-
Try this, if it doesn't work, the problem isn't with the BIOS. It can't be the same problem in all BIOSes. It might be because the programmer you're using is old. I don't know how to use this....Leave a comment:
-
Can you try this and let me know the results? It may have to restart your computer 5 timeS.You may need to enter the correct display and processor information on the installation screen....Leave a comment:
-
Can you try this and let me know the results? It may have to restart your computer 5 times and I cleaned it up myself....Leave a comment:
-
Can you try this and let me know the results? It may have to restart your computer 5 times and I cleaned it up myself....Leave a comment:
-
You can try it and reply, master. You need to write it as a set. If it still shuts down, the fault is not related to the bios....Leave a comment:
-
thank you master, thank you...Leave a comment:
-
I have a Dell e7440 la-9591p motherboard, no matter what I did on the device, I couldn't start it. It uses MEC5075. On the first page, someone shared the jtag paths for tx390, I searched from the schematic and found the same legs. Can I make this read by soldering it in the same way as SWOD? or with rt809f? or what are its legs? Also, I think the place where it says rp1 is for jtag, but there is a resistor with 103 written on it. Can I remove it, solder the 5 paths and 3 gnds and read it?...
Leave a comment:
-
I would be very happy if you could help me with one more issue, the bios is in good condition, thanks to you, I made it factory clean. But I don't know how to do EC on older models. I would be very happy if you could help me on how to do the EC of this device.Leave a comment:
-
The device I use is an imac, actually I will try this on the Mac side at the first opportunity. I struggled because the Dell FPS extractor was not working on the Windows side. It didn't work when I did it in Windows like you did. Thank you friend, I solved it, but I will try it on the Mac side at the first opportunity. Thank you very much for your interest. Good luck with your work....Leave a comment:
-
Thank you very much king, I did what you said one by one and as a result I was successful and I am happy. Thank you for your hard work....
Leave a comment:
-
This is a BIOS exe file belonging to a Dell E7440. I couldn't open it with InnoExtractor, UniExtractor, 7Zip, WinRar, ResurceHacker, or any other program or Python file. When I double-click it, nothing comes up. If it does, I can extract the dump file from the Temp folder. How can I open it? Can you help me?Leave a comment:
No activity results to display
Leave a comment: