Re: Tv Digihome 50292UHDDLEDCNTD restarts and blinking standby light
I have removed the chip from the board and it worked.
Sadly, I have damaged the pads on the boards when I removed it. I have used the hot air gun, done some practice on a scrap board, set to 280C, all fine.
When I moved onto the actual board, the chip would not come off like the solder wasn't melting. After increasing the temperature a little bit (320C) and keeping the air gun on it for longer time it eventually came off but also the pads and traces.
It was a good experience and I think I need to practice more. Looking forward
to the next project.
Thanks everyone for help!
Originally posted by R_J
View Post
Sadly, I have damaged the pads on the boards when I removed it. I have used the hot air gun, done some practice on a scrap board, set to 280C, all fine.
When I moved onto the actual board, the chip would not come off like the solder wasn't melting. After increasing the temperature a little bit (320C) and keeping the air gun on it for longer time it eventually came off but also the pads and traces.
It was a good experience and I think I need to practice more. Looking forward
to the next project.
Thanks everyone for help!
Comment