Re: whole new repair / learning world... plasma! Yikes!
MID is across the two blue caps on the right of this image.
https://www.badcaps.net/forum/attach...6&d=1524904441
It's generally 80-120VDC, or half Vsus +/- 10%.
The green light should glow on the board if VMID is good.
If VMID is low then there is a good chance that your sustain output is not, uh, sustaining.
A scope is helpful at this point.
MID is across the two blue caps on the right of this image.
https://www.badcaps.net/forum/attach...6&d=1524904441
It's generally 80-120VDC, or half Vsus +/- 10%.
The green light should glow on the board if VMID is good.
If VMID is low then there is a good chance that your sustain output is not, uh, sustaining.
A scope is helpful at this point.
Comment