Panasonic TX-P42V10E ( 7 blinks fix )

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Moreno83
    Badcaps Legend
    • Jun 2014
    • 2008
    • The Netherlands
    #1

    Panasonic TX-P42V10E ( 7 blinks fix )

    YHey guys ,

    I bought this nice tv cheap with the symptom that it would blink 7 times.
    When i placed the tv in my car i noticed that there was a small black spot on the panel. Panel was not cracked so i left it as is.....

    Got home and isolated the buffer boards. Used the sc50 jumper and tv turned on for 5/6 seconds and then turned off with again 7 blinks. Instead of the hd jumper i used a screw and now it stayed on but turned off with 11 blinks. Reseated all fan cables and woohoo it stayed on!!

    Replaced both buffer boards and i got a nice pict..uhm , ok thats not a nice picture.

    The panel somehow got burned from the inside which probably killed the buffer boards. Shame but you cant always be lucky....
    Attached Files
    I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • Andre Gilbert
      Panasonic TC-P55ST50 8 blinks then no blinks
      by Andre Gilbert
      Hello! yes I know there is already lots of information about this issue. I have a Panasonic TC-P55ST50 that originally displayed an 8-blink error code. Following the troubleshooting flowchart, I ended up replacing the SS board. However, even after replacing it, the issue persists. The TV turns on and stays on without displaying an image, and continuity is confirmed on all connectors. What am I missing here🤔?
      Ok Im a mechanical engineer ...but I thought I was able to follow a rather simple flowchart for electric troubleshooting 😂.

      TV Model: Panasonic TC-P55ST50
      ...
      1 Photo
      11-20-2024, 08:52 PM
    • howardc64
      TCL 55S425 few horizontal lines, potential failure on both side of panel/buffer board
      by howardc64
      All left and right refers to looking from rear of TV (or looking from front with TV upside down)
      • TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
      • Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
      ...
      07-24-2025, 05:17 PM
    • Biruslapio
      Panasonic P58V11B 8 and 12 blinks error "fix"
      by Biruslapio
      Bought this TV used not working, panel flashed briefly on power up and it was blinking 8 times, a quick look on SS board revealed a common fault on the 3uF 250V capacitors, C201 to C205 (C1620X in the service manual), the solder joints were all cracked, C201 and C205 pins were darkened and some sparking had occurred on them, C201 was split open and clearly overheated in its last hours, replaced that one and resoldered the others, 8 blinks fixed.

      Also the previous owner broke the antenna connector by taking the TV out of the wall mount forgetting to unplug it, I desoldered the tuner...
      04-13-2021, 07:13 AM
    • jm1234
      Panasonic plasma TX-P42ST50 - 6 blinks
      by jm1234
      Hi,
      anyone able to provide the service manual for old plasma Panasonic TX-P42ST50E?
      It turns off almost immediately (0~5 seconds after pressing the on/off button) and starts flashing the red diode 6 times.
      I disconnected the left-hand side board (SC?, both the ribbon cable and the power cable to it) and also another ribbon going to bottom left board. Then the led signal is 8 flashes. According to service guide to another Panasonic plasma it would mean the left-hand side board is faulty. But I'm not sure it 100% applies to my model.
      I checked that board for any obvious faults...
      05-22-2024, 06:59 AM
    • Alicat
      Panasonic Plasma TH-50PZ85U No screen No blinks on red power light
      by Alicat
      Hello,

      Stopped by this site trying to fix my parents Panasonic Plasma TV.

      Model number is TH-50PZ85U

      Power comes on and the red power light stays on solid.

      Did a few checks like hold the power button on for 60 seconds, hold the - Volume while holding the menu button, no luck, still@ blank grey screen as the screen lights up very vague.

      I also hear a few clicks.

      I also think my parents said there was a thunderstorm and the TV failed after that.

      Section 6 in the service manual talks about power and no screen,...
      10-30-2024, 10:09 AM
    • Loading...
    • No more items.
    Working...