My wife said it acted like it was turned to a channel we didn't get (scrambled). I turned it on (standby light was on) the light never went out and the tv didn't turn on. Took the tv down and top the back off. When plugged in the top green led on the logic board (i think that's the term) flashes then the green led under it comes on for a second or two. This happens at the same time I hear a click from the power board.
I've followed this thread
https://www.badcaps.net/forum/showthread.php?t=20590
All of my voltages check out that are listed
Vs on the two boards are 200 when it powers on
Va on the y is 56
Ps on is 3.25 when off .12 when on
I tried unplugging the boards and powering on severally with no changes.
I checked the removable fuses and the soldered ones as listed in the post.
All the capacitor appear to be good, noting obvious.
I did not pull any boards to check for solder joints.
What's different with mine compared to the linked thread is that his green leds didn't flash and my red led on the front of the tv does not go out.
Help please! Thanks
I've followed this thread
https://www.badcaps.net/forum/showthread.php?t=20590
All of my voltages check out that are listed
Vs on the two boards are 200 when it powers on
Va on the y is 56
Ps on is 3.25 when off .12 when on
I tried unplugging the boards and powering on severally with no changes.
I checked the removable fuses and the soldered ones as listed in the post.
All the capacitor appear to be good, noting obvious.
I did not pull any boards to check for solder joints.
What's different with mine compared to the linked thread is that his green leds didn't flash and my red led on the front of the tv does not go out.
Help please! Thanks
Comment